Reference Guide

Version Description
7.6.1.0 Introduced on the C-Series and S-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information To assign traffic to different flows using QoS policy, use the Output Policy map.
This command enables Policy-Map-Output Configuration mode (conf-policy-
map-out).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy output — applies an output policy map to the selected interface.
qos-policy-input
Create a QoS input policy on the router.
C9000 Series
Syntax
qos-policy-input qos-policy-name [layer2] [cpu-qos]
To remove an existing input QoS policy from the router, use the no qos-policy-
input qos-policy-name [layer2] [cpu-qos] command.
Parameters
qos-policy-name Enter the name for the policy map in character format (32
characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is Layer 3.
cpu-qos Enter the keyword cpu-qos to create a QoS input policy to
be used to rate-limit control-plane traffic (CoPP).
Defaults Layer 3
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
1704
Quality of Service (QoS)