Reference Guide

slot/port-range
Enter the slot/port-range to specify a linecard and either a
single port number, a port range, or a combination of both
for auto-LAG configuration.
Slot number range is from 0 to 9. In linecard slots 0 to 9, the
range of port numbers is from 0 to 23.
Default None
Command Modes PE CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
This command provisions the port extender for automatic link aggregation group
(LAG) port channel creation on the connected ports. The LAG member ports must
be operationally up and have a default port configuration with no Layer 2 and Layer
3 configuration. The port interfaces must be of the same type. You can configure
up to 16 switch ports in the auto-LAG.
• The slot/port-range specifies a line card and either a single port number, a port
range, or a combination of both for auto-LAG configuration. The range of slot
numbers is from 0 to 9 for linecard slots. The range of port numbers is from 0
to 23.
Example
Dell(conf)# feature extended-bridge
Dell(conf)# pe provision 2
Dell(conf-pe-4)#cascade interface tengigabitethernet 1/1-2
clear pe statistics
Delete the statistics related to a specified port extender.
C9000 Series
Syntax
clear pe pe-id statistics
Parameters
pe-id Enter the keyword pe and the port extender ID. Range is
from 0 to 255.
1614
Port Extenders (PE)