Administrator Guide

[1d0h24m]: CMD-(CLI):[no shutdown]by default from console

[1d0h25m]: CMD-(CLI):[end]by default from console

[1d0h25m]: CMD-(CLI):[write memory]by default from console

- Repeated 1 time.

[1d0h25m]: CMD-(CLI):[show clock]by default from console

[1d0h25m]: CMD-(CLI):[show version]by default from console

[1d0h25m]: CMD-(CLI):[show logging]by default from console

[1d0h25m]: CMD-(CLI):[show command-history]by default from console

Example 4: no service timestamps log

DellEMC(conf)#no service timestamps log

DellEMC# show command-history

- Repeated 1 time.

[1d0h26m]: CMD-(CLI):[configure]by default from console

- Repeated 1 time.

[May 17 15:53:10]: CMD-(CLI):[no service timestamps log]by default from console

[May 17 15:53:16]: CMD-(CLI):[write memory]by default from console

- Repeated 3 times.

[May 17 15:53:22]: CMD-(CLI):[show logging]by default from console

- Repeated 1 time.

[May 17 15:53:36]: CMD-(CLI):[write memory]by default from console

- Repeated 5 times.

[May 17 15:53:44]: CMD-(CLI):[show logging]by default from console

[May 17 15:53:53]: CMD-(CLI):[show command-history]by default from console

[May 17 15:54:54]: CMD-(CLI):[end]by default from console

[May 17 15:55:00]: CMD-(CLI):[show logging]by default from console

[May 17 15:55:12]: CMD-(CLI):[show clock]by default from console

[May 17 15:55:22]: CMD-(CLI):[show running-config]by default from console

[May 17 15:55:27]: CMD-(CLI):[show command-history]by default from console

Upgrading the Dell Networking OS

To upgrade the Dell Networking operating system on the switch, refer to the Release Notes for the software version you want

to load.

NOTE:

If VLT is already configured in a device loaded with Dell Networking OS version 9.9(0.0), you must first remove the

VLT configuration to upgrade to the Dell Networking OS version 9.10(0.0) or later. After removing the VLT configuration,

upgrade each VLT node and its corresponding single-homed PE individually and then reload both nodes as well as PEs. After

the CBs and PEs come up with Dell Networking OS version 9.10(0.0) or later, configure VLT again. When you configure

VLT, the PEs first go down and then come up.

For information about how to verify newly copied or currently running software images, see:

● Using Hashes to Validate Software Images

Getting Started