Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage
Information
The following describes the show ip cam command shown in the following example.
Field Description
Index Displays the CAM index number of the entry.
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for the default
route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is
more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 if the entry is for a line card with Catalog
number beginning with LC-EF.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the
CP or RP2, depending on Egress port.
Next-Hop Displays the next hop IP address of the entry.
VId Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to determine the
interface. For example, in the entry 17cl CP, the CP is the pertinent portion.
● CP = control processor
● RP2 = route processor 2
● Gi = Gigabit Ethernet interface
● So = SONET interface
● Te = 10-Gigabit Ethernet interface
Example
Dell#show ip cam linecard 0 port‐set 0
Destination EC C VId Mac‐Addr Port
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
1.1.32.140/32 0 0 200 00:00:00:00:1f:8a PeGigE <PE‐ID>/<Slot>/<Port>
show ip fib linecard
View all forwarding information base (FIB) entries.
C9000 Series
Syntax
show ip fib linecard linecard id {vrf <vrf-id>/<A.B.C.D>/summary}
Parameters
linecard Displays the fib entries for the mentioned linecard id.
936 IPv4 Routing