Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
ip domain-list
Configure ip domain names to complete unqualified host names.
C9000 Series
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
name Enter an ip domain name to complete unqualified names (that is, incomplete domain
names that cannot be resolved).
Defaults Disabled.
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage
Information
To configure a list of possible domain names, configure the ip domain-list command up to six times.
If you configure both the ip domain-name and ip domain-list commands, the software tries to
resolve the name using the ip domain-name command. If the name is not resolved, the software goes
through the list of names configured with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
● specify a domain name server with the ip name-server command
● enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related configuration, use the
show running-config resolve command.
Related
Commands
ip domain-name — specifies a DNS server.
918 IPv4 Routing