Users Guide

Status Code
677
116-790
[Cause] Probable causes are as follows:
1)If the operator cancelled printing a document that was received using the Store Fax -
Local Folder or Store Internet Fax - Local Folder feature:
The first set of the document is not stapled.
2)For causes other than 1)
No set of the document is stapled.
[Remedy] For 1), manually staple the first set of the document. Or, do not cancel printing of a
document that is received using the Store Fax - Local Folder or Store Internet Fax -
Local Folder feature.
For 2), check whether the staple position has been correctly specified, and try printing
again.
117-312
[Cause] An error occurred in the machine.
[Remedy] Contact Customer Support at dell.com/contactdell.
117-326
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
117-331
117-332
117-333
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
118-310
[Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
118-311
[Cause] An error occurred during software processing.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
121-311
[Cause] An error occurred between the machine and the device connected.
[Remedy] Once a smart card reader is connected to the machine, the machine automatically
changes the [Passcode Entry for Smart Card Login] setting to [On] under [Tools] >
[Authentication / Security Settings] > [Authentication] > [Passcode Policy]. Change
the setting as required.
121-314
121-316
121-318
121-319
121-320
121-321
121-322
121-323
121-324
[Cause] An error occurred between the machine and the device connected.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact Customer
Support at dell.com/contactdell.
121-333
[Cause] An error occurred between the machine and the device connected.
[Remedy] Confirm that the device is switched on, and then switch off the machine power, make
sure that the touch screen is blank, and switch on the machine power. If the error still is
not resolved, contact Customer Support at dell.com/contactdell.
Status Code Cause and Remedy