Administrator Guide
13 Appendix
486
Print control 51
(Blank sheet
output)
Sets whether to print blank pages if included in the document.
[0] (Default) : Off
[1] : On
Note • Even when [Off] is selected, blank pages are printed if they are spaces
created with user-defined characters or images in white color.
• When [Off] is selected for this feature and 2 Up or 2 sided printing is
specified, blank pages are not printed.
52
(Character
print area)
Extends the position of the right margin.
[0] (Default) : Standard
[1] : Extended
Note • Changing the character print area from [Extended] to [Standard] restores
the left and right margins to the default values.
• When the position of the right margin is set here, that position becomes the
right edge of the character print area.
53
(Image
enhancement)
Sets whether or not to enable the Image Enhancement feature.
Image Enhancement smoothens the border between black and white,
reducing rough edges, and thus seemingly increasing the resolution.
[0]
: Off
[1] (Default) : On
ESCP switch 55
(Text quality)
Sets the Text Quality mode to high quality or draft.
[0] (Default) : High Quality
[1] : Draft
Note • Since the default value is selected for the [Text Quality], [Reduced
Characters], [Character Code Table], [Page Length], and [1-inch Perforation
Skip] features, their settings will not be affected when an extended
command is received.
• Changing settings does not change actual printing quality.
• This setting affect the Text Quality selection commands. For more
information on the Text Quality selection commands, contact Customer
Support at dell.com/contactdell.
56
(Reduced
characters)
Reduces the size of single-byte alphanumeric characters when printing. Sets
whether to reduce their sizes or to print them at a scale of 100%.
[0] (Default) : Off
[1] : On
58
(Page length)
Sets the length of a page (printable area) to 11 inches or 12
inches.
[0] (Default) : 11 inches
[1] : 12 inches
59
(1-Inch
perforation
skip)
Sets whether or not to leave a 1-inch space between pages.
[0
] (Default) : Off
[1] : On
Note • This is effective only when CSF under [Paper Position] is set to [Off].
60
(Paper feed
position)
Sets the position to
start printing at 8.5 mm or 22
mm below the top edge of
paper.
[0] (Default) : 8.5 mm
[1] : 22 mm
ESCP switch 61
(CR feature)
Sets the action to be executed when a CR command is received.
[0] (Default) : Carriage return
[1] : Carriage return and linefeed
Setting Item Item Number Value