Administrator Guide

5 Tools
162
SOAP
Port Status
Select [Enabled] when you use an application program.
Port Number
Enter a port number for SOAP from 1 to
65535.
The default value is 80.
Note • If the default port number is used, it may conflict with other ports. Make sure to set up the port number
that is not in use.
WebDAV
Port Status
Select [Enabled] when you use an application program such as Network Scanner Utility3 to
access folders in the machine.
Note • You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine, and
then configure [Port Number] and [Operation Time-Out].
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Note • If the default port number is used, it may conflict with other ports. Make sure to set up the port number
that is not in use.
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint .print environment. The machine
decompre
sses and prints the compressed print data sent from the print server.
Select [Enabled] when you use ThinPrint
®
.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Note • Do not use any numbers assigned to the other ports.
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections a
re possible at a time.
Protocol Settings
Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.