Reference Guide

Brocade Fabric OS Command Reference 627
53-1004112-02
portCfg
-v | --vlan value
Set the VLAN input filter for the specified TCL. The range is from 0 to 4095.
--l2cos value
Sets the Layer 2 CoS input filter for the specified TCL.
--l4proto num | name
Sets the Layer 4 protocol input filter for the specified TCL. Valid values for name are
TCP, UDP, ICMP, VRRP and the valid range for num is from 0 through 255, or 'none'
to clear the Layer 4 protocol input filter.
--rst-propagation enable | disable
Enables or disables end-to-end RST propagation for the specified TCL.
--segment-preservation enable | disable
Enables or disables segment preservation for the specified TCL.
--non-terminated enable | disable
Enables or disables non-terminate traffic handling for the specified TCL.
mgmtif
Configures an inband management interface. A maximum of one interface is supported per
GbE Port. Up to a total of 11 interfaces for the Brocade FX8-24 (depending on blade
operating mode). The interfaces must each exist on a unique network, separate from the
other inband management interfaces and from all other interfaces on the CP. The syntax for
mgmtif is as follows:
mgmtif ge_port [options] arguments
Valid options and arguments for mgmtif include the following:
create
Creates a specified IP Address for the inband management interface. The IP address must
be unique.
IPv4_address
Specifies an IP address for the inband management interface in IPv4 format, followed
by the subnet mask.
netmask
Specifies the subnet mask for the IPv4 address in a.b.c.d format.
MTU
Specifies the MTU for the inband management interface. The valid range is 1260 to
1500. This operand is optional.
delete
Deletes the specified IP Address for the inband management interface.
IPv4_address
Specifies the IP address to be deleted.
disable
Disables the inband management interface at the specified GbE Port.