User`s guide

1. Introduction

Installing the driver locally

A locally connected machine is a machine directly attached to your computer

using the cable. If your machine is attached to a network, skip the following

steps below and go on to installing a network connected machine’s driver (see

"Installing driver over the network" on page 141).

• If you are a Mac or Linux operating systems user, refer to the "Installation

for Mac" on page 131

or "Installation for Linux" on page 133.

• The installation window in this

User’s Guide may differ depending on the

machine and interface in use.

• Only use a USB cable no longer than 3 meters (118 inches).

Windows

Make sure that the machine is connected to your computer and

powered on.

If the “Found New Hardware Wizard” appears during the installation

procedure, click Cancel to close the window.

Insert the supplied software CD into your CD/DVD drive.

The software CD should automatically run and an installation window

will appear.

If the installation window does not appear, click Start > All programs >

Accessories > Run.

X:\Setup.exe replacing “X” with the letter, which represents your CD/

DVD drive and click OK.

• For Windows 8,

If the installation window does not appear, from Charms, select

Search > Apps and search for Run. Type in X:\Setup.exe, replacing

“X” with the letter that represents your CD/DVD drive and click OK.

If “Tap to choose what happens with this disc.” pop-up window

appears, click the window and select Run Setup.exe.

Select New Printer.