Service Manual


11. Lift and slide the video-card(s) out to disconnect it from the connector on the system board.
Replacing the Video Card(s)

1. Follow the instructions in Before You Begin.

2. Insert the video card connector at a 45-degree angle into the connector on the system board.

3. Press the other end of the video-card down into the slot on the system board and replace the two screws that secure the video-card(s) to the system
board.

4. Replace the video-card heat-sink(s) (see Replacing the Video-Card Heat- Sink(s)).

5. Follow the instructions from step 4 to step 7 in Replacing the Palm Rest.

6. Replace the display assembly (see Replacing the Display Assembly).

7. Replace the macro keyboard (see Replacing the Macro Keyboard).

8. Replace the keyboard (see Replacing the Keyboard).

9. Replace the center control cover (see Replacing the Center Control Cover).

10. Replace the base cover (see Replacing the Base Cover).

11. Replace the battery pack (see Replacing the Battery Pack).

Back to Contents Page

1
secondary video card
2
screws (2)
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.