Owner`s manual

System Setup

System Setup Overview

System Setup allows you to:

• change the system configuration information after you add, change, or remove any hardware in your computer.

• set or change a user-selectable option such as the user password.

• read the current amount of memory or set the type of hard drive installed.

• check battery health.

Before you use System Setup, it is recommended that you write down the System Setup screen information for future

reference.

CAUTION: Unless you are an expert computer user, do not change the settings for this program. Certain changes

can cause your computer to work incorrectly.

Boot Sequence

Boot Sequence allows you to bypass the System Setup‐defined boot device order and boot directly to a specific device

(for example: optical drive or hard drive). During the Power-on Self Test (POST), when the Dell logo appears, you can:

• Access System Setup by pressing <F2> key

• Bring up the one-time boot menu by pressing <F12> key

The one-time boot menu displays the devices that you can boot from including the diagnostic option. The boot-menu

options are:

• Removable Drive (if available)

• STXXXX Drive

NOTE: XXX denotes the SATA drive number.

• Optical Drive

• Diagnostics

NOTE: Choosing Diagnostics, will display the ePSA diagnostics screen.

The boot sequence screen also displays the option to access the System Setup screen.

Navigation Keys

The following table displays the system setup navigation keys.