User's Manual

3.
4.
Reset the wireless setting of the printer following the steps on the Reset Wireless Setting screen.5.
In the list on the Select Printer screen, check the check box of the target printer that you are making
wireless setting for, and then click Next. On the Enter Wireless Network Settings screen, set each
wireless setting item, and then click Next. When you select the Fixed IP option button for IP
Address assignment, click Change... and enter the IP address and subnet mask on the screen.
6.
NOTE: When you enter a fixed IP address, avoid the "169.254.xxx.xxx" address used by AutoIP.
Set each item on the Enter Printer Settings screen, and then click Next.7.
On the Printer Software screen, specify the software that you want to install and installation path,
and then click Next. At this point, the wireless setting specified on the Enter Wireless Network
Settings screen is sent to the printer.
8.
On the Wireless configuration is now complete screen, click Next. Since wireless setting is already
made to your computer, no operation is necessary on this screen.
9.
On the Setting-Ready Printer screen, verify that the correct IP address is assigned to the printer to
which the wireless setting is set, and then click Install.
10.
NOTE: If your system has any of the following operating systems:
Windows XP x64
Windows Server
®
2003 x64
Windows Vista x64
Windows Vista x86
,skip step 11 and go to step 12.
If you select the I am setting up this printer on a server check box on the Select Printer screen
and also select the PostScript Driver check box on the Enter Printer Settings screen, the Adobe
Systems Inc. License Agreement screen appears. Select the I accept the terms of the license
agreement option button, and then click Install.
11.
On the Congratulations! screen, click Finish to complete the installation. A test page will be printed
with the installed printer by clicking the Print Test Page button.
12.
Scene 2. Construct new wireless network environment for both computer and printer (When wireless setting
needs to be set to your computer)
Insert the Drivers and Utilities CD into your computer.1.
The Drivers and Utilities CD should launch the installation software automatically.
If the CD does not automatically launch, click Start Run, type D:\Setup.exe (where D is the drive
letter of your CD), and then click OK.
2.
NOTE: For Windows Vista, click Continue when the User Account Control dialog box appears.
Select the Network Installation option button, and then click Next.3.
Select the Configure Wireless Printer using a USB connection (Recommended) option button,4.
5.