Mono Laser Printer User's Guide

View supplies
This message shows the current level of supplies.
Waiting
The printer has received data to print, but is waiting for an End-of-Job command, a Form Feed command, or additional
data.
Try one or more of the following:
• Press to print the contents of the buffer.
• Cancel the current print job.
30 Invalid refill, change cartridge
Remove the print cartridge, and then install a supported one.
31 Replace defective cartridge
Remove the defective print cartridge, and then install a new one.
32 Cartridge part number unsupported by device
Remove the print cartridge, and then install a supported one.
34 Short paper
Try one or more of the following:
• Load the appropriate paper in the tray.
• Press the arrow buttons until
Continue appears, and then press to clear the message and print the job
using a different paper tray.
• Check tray length and width guides and make sure the paper is properly loaded in the tray.
• For Windows users, check the Print Properties settings to make sure the print job is requesting the correct paper
size and type.
For Macintosh users, check the Print dialog settings to make sure the print job is requesting the correct paper
size and type.
• Check that the paper size is correctly set. For example, if the MP Feeder Size is set to Universal, make sure the
paper is large enough for the data being printed.
• Cancel the current print job.
Understanding printer messages
156