Owner`s manual

Installing the Palmrest

1. Starting from the edges of the palmrest, press downwards on the palmrest to engage the tabs on the computer.

2. Tighten the screws to secure the palmrest to the front of the computer.

3. Connect the functions button cable to the system board.

4. Connect the touchpad cable, SD card reader cable, and fingerprint scanner cable to the system board.

5. Connect the power button fingerprint cable to the system board.

6. Tighten the screws to secure the palmrest to the back of the computer.

7. Connect the LEDs fingerprint cable to the system board.

8. Tighten the screws on the bottom of the computer that secure the palmrest in place.

9. Push the rubber pads to cover the screws on the computer.

10. Install the:

a) display hinge cover

b) keyboard

c) hard drive

d) optical drive

e) memory

f) base cover

g) battery

11. Follow the procedures in

After Working Inside Your Computer

Removing the ExpressCard Reader

1. Follow the procedures in

Before Working Inside Your Computer

2. Remove the:

a) SD Card

b) express card

c) battery

d) base cover

e) keyboard