Instructions / Assembly
DOME COVER
Item #: 1002484076
Model #: 99657
USE AND CARE GUIDE
8-PACK PUCK LIGHTS WITH REMOTE CONTROL
10
MIN
30
MIN
60
MIN
120
MIN
10
MIN
30
MIN
60
MIN
120
MIN
Safety Information
Pre-Operation
Operation
Care and Maintenance
Troubleshooting
Warranty
Use caution and common sense when operating your puck light.
Failure to adhere to the safety warnings and guidelines in this manual could result in body injury or property
damage. Save this manual for future reference.
1. This product is not a toy and contains small parts. Close supervision is necessary when this unit is used near children or
operated by children.
2. For cleaning, use a soft dry cloth. Do not place or store appliance where it can fall or be pulled into a tub or sink.
□ If the light does not work, make sure the battery is installed correctly or brand new.
□ If the remote control does not work, make sure the plastic sheet is removed and battery is installed correctly or brand new.
□ If the remote control is not working properly, make sure there is no obstacle between you and the puck light(s), and that
the remote is not positioned too far away from the lights.
□ When replacing batteries always replace the whole set.
□ Use same brand and same type of batteries in the same light.
□ Do not use rechargeable or reusable batteries
□ Follow battery manufacturer’s instructions as to proper handling, storage and disposal of batteries.
1. Operating the Puck Lights
A. Operating by Touch Control
Once the 3 AAA batteries are installed, turn on each puck by lightly pressing the Dome
Cover. Repeat pressing the Dome Cover to change the color (white, red, green, or
blue) or turn the unit OFF.
B. Operating by Remote Control
□ Press “ ” to turn all lights ON, press “ ” to turn all lights OFF.
□ “ ” is to control brightness of all lights. Press and hold (+) or (-) to
increase and decrease brightness separately.
□ “ ” is to control the amount of time the lights stay ON. Turn the
lights ON rst and select duration among 10, 30, 60, or 120 minutes.
Lights will ash once to conrm command. Timer clears when lights
turn OFF.
□ Color selector- Change color of LEDs to be white, red, green or blue.
□ All lights will return to the prior color when turned ON.
2. Mounting Instructions
Remove the protective paper on one side of the mounting pad (D) and apply to the
battery cover (use caution as the adhesive is very strong). Decide a location to
position the light. Remove the second protective paper and apply pressure to set
the adhesive. Once applied the light is permanently mounted.
1. Package Contents
A
B
C
2. Battery Installation and Replacement
Puck Lights-Each light requires 3 AAA batteries (C).
□ Remove the battery cover by rotating to “ ”
position as indicated.
□ Place 3 AAA batteries (C) into the battery
compartment aligning polarity (+) (-) as indicated.
□ Replace the battery cover, ensure the “ ” on the
upper and bottom cover are aligned, and turn to the
“ ”position.
Remote Control-One piece CR2025 button battery pre-installed.
Remove the insulation sheet upon rst use. Follow these steps to
activate or replace the battery:
□ Slide the battery drawer out.
□ Remove the battery.
□ Place a new battery in position aligning polarity(+) (-) as indicated.
□ Slide the battery drawer in.
□This product is guaranteed to be free of defects in materials and workmanship for 1 year from the date of purchase. If this
product is defective, call 866-308-3976 for repair of replacement parts or return the product to the store from which it was
purchased.
□Guarantee does not include normal wear and tear, LED or batteries.
WARNING: Read and follow all warnings
and instructions in this manual to avoid
personal injury or property damange.
WARNING: To prevent damange to eyesight,
never look into light when the light is on. Do not
shine light into the face of someone else.
10
MIN
30
MIN
60
MIN
120
MIN
10
MIN
30
MIN
60
MIN
120
MIN
10
MIN
30
MIN
60
MIN
120
MIN
AAA
AAA
AAA
D
257*182mm
Part Description Quantity
A
B
C
D
Puck Light
Remote Control
AAA Heavy Duty Battery
Mounting
8
1
24
8
FRONT