Use and Care Manual

USE AND CARE SPECIFICATIONS
The sooner Ipe Seal™ is applied to lumber ends or log ends after end cutting, the more effective it will be in preventing
end checking and degrade. Similar in viscosity to latex paint, Ipe Seal™ is easily brushed or sprayed on.
VEHICLE TYPE
Water-based, wax & plant-based polymer emulsion.
APPEARANCE
Viscous, white liquid that dries to waxy clear.
COLORS
Available in Clear.
VOC CONTENT
VOC 0 g/l - 0.0 lb/gl
VISCOSITY
3,500 – 4,500 Cps at 25°C / 77°F (LVT Brookfield)
SPECIFIC GRAVITY:
0.97 - 0.99 typical
WEIGHT PER QUART
1.5 Pounds
COVERAGE
One quart covers roughly 500 sq. ft. of lumber ends.
DRY TIME
Dries to the touch in less than 1-2 hours.
APPLY WITH
Brush, roller, airless spray
PACKAGING
One U.S. quart / 0.95 Liters
STORAGE
Store at ambient temperature, above 5ºC / 40ºF. Product can
be damaged by freezing.
APPLICATION
Always clean dirty wood end grain before applying Ipe Seal™.
Apply a liberal even coating to the end grain of the wood. Brush from
the bottom upwards on deck boards and apply liberally on log ends.
Thorough, complete coverage of the end grain will maximize the
benefits for your lumber.
Logs over 24” (60 cm) should be coated very heavily or twice within a
15 minute period to preserve value.
CLEAN UP
Use hot, soapy water to clean equipment. Solvent cleaners are not
recommended.
PROPERTIES & STORAGE
Ipe Seal™ is a stable, non-toxic (w/o methanol), non-hazardous,
wax and water emulsion.
Ipe Seal™ should be kept in temperature controlled areas above
50°F/10°C and not exceed 95°F/35°C.
Questions/Comments: www.DeckWise.com
The Ipe Clip
®
Fastener Company, LLC
The Ipe Clip
®
Fastener Company, LLC
Phone: [phone] • Email: [e-mail]
Web: www.DeckWise.com
DeckWise
®
, The Ipe Clip
®
Fastener Company, LLC • 2111 58th Ave. East, Bradenton, FL 34203C • All rights reserved. ©Copyright 2017