Installation Guide

INSTRUCTION GUIDE
©2023 Oatey SCS. All Rights Reserved. This information is based on data believed to be reliable but Oatey makes no warranties, express or implied, as to its accuracy and assumes no liability arising out
of its use. The data listed falls within the normal range of product properties but should not be used to establish specication limits or used alone as the basis of design. Oatey’s liability to purchasers is
expressly limited to the terms and conditions of sale. Oatey is trademark of Oatey Co. All other trademarks can be found www.Oatey.com.
Oatey.com
1
2
5
10
8
6
9
4
7
Slide bottle trap (C) up against the top of the plastic tube (B) and handtighten chrome nut (A) onto the bottle trap (C).
3
Push plastic tube (B) onto tailpiece to the rst internal rib.
Place escutchueon plate (G), existing slip nut and slip washer onto waste arm (F).
Slide chrome nut (A) onto vertical tailpiece.
Measure and cut waste arm (F) to desired length.
Tighten all nuts to create a water tight seal and CHECK FOR LEAKS.
NOTE: Bottle trap clean out is located at the bottom of (C). Insert athead screwdriver into
slot on clean out cap. Rotate counterclockwise until cap releases. Remove O-ring and any
debris. Clean O-ring and cap before replacing. Tighten cap. CHECK FOR LEAKS.
Slide waste arm (F) into wall trap adaptor rst and handtighten slip nut.
Place bottle trap slip washer (D) and chrome slip nut (E) onto waste arm (F).
Slide waste arm (F) into the bottle trap (C).
Cut tailpiece from pop-up assembly or grid drain to desired length.
BOTTLE TRAP