instructions CITRUS PRESS KS3000M Please retain these instructions for future use
Description of Appliance The following terms are used throughout the instruction manual Dust cover Fruit dome Top filter Bottom filter Pulp density selector Internal juice container Non-drip spout Lever ring Juicing lever Motor shaft Motor base Citrus juicer KS3000 2
Thank you for choosing this De’Longhi citrus press. To get the best results from your new citrus press it is advisable to read these instructions carefully before using the appliance. This is the only way to ensure optimum results and maximum safety. Using for the first time • Before use, check that the appliance has not been damaged during transport. • Remove all packaging from the citrus press.
Fig.5 NB: the pulp density selector enables the quantity of pulp in the juice to be regulated by making the holes in the filter smaller or larger. To reduce the amount of pulp, move the juice density selector left as far as it will go.To increase the quantity of pulp, move the selector to the opposite side (fig. 5). Important: never use the appliance continuously for more than four minutes. • When you have finished juicing, to reduce drips, move the nondrip spout to the raised position (fig. 6).
• The appliance should be destined exclusively to the use for which it has been created. Any other use is to be considered inappropriate and therefore dangerous. The manufacturer cannot be held responsible for any damage caused by improper, erroneous or irresponsible use and/or by repairs made by unqualified personnel. • Do not touch the appliance with wet or damp hands. • Do not use the appliance with bare or wet feet. • Do not unplug the appliance by pulling the plug out of the socket by the cord.
Warning this appliance must be earthed Green and Yellow to Earth 13 amp Fuse Blue to Neutral Brown to Live Cord Clamp Electrical Requirements The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
444IDL/06.
