Freezer DFS920JE LES NOUVEAUX OBJETS DE VALEUR
Contents Safety information Control panel First use Daily use Helpful Hints and Tips 2 4 5 5 6 Care and cleaning What to do if… Technical data Installation Environmental concerns 7 7 9 9 13 Subject to change without notice Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
• It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used.
Temperature regulation The temperature within the appliance is controlled by the Temperature regulator situated at the top of the cabinet. To operate the appliance, proceed as follows: • turn the knob clockwise to obtain the maximum coldness • turn the knob counter- clockwise to obtain the minimum coldness. The intermediate position is usually the most suitable.
The maximum amount of food that can be frozen in 24 hours is specified on the rating plate , a label located on the inside of the appliance. The freezing process lasts 24 hours: during this period do not add other food to be frozen. Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings.
• Once defrosted, food deteriorates rapidly and cannot be refrozen. • Do not exceed the storage period indicated by the food manufacturer. Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
Problem Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The Pilot light flashes. The appliance is not working properly. Contact a qualified electrician. The buzzer sounds.
Technical data Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 21 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
13mm 2,5 Ventilation requirements The airflow behind the appliance must be sufficient. min. 200 cm2 min. 200 cm2 2. Install the appliance in the niche. Push the appliance in the direction of the arrows (1) until the upper gap cover stops against the kitchen furniture. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. Push the appliance in the direction of the arrows (2) against the cupboard on the opposite side of the hinge.
The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. 4mm 6. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. 44mm 4. Attach the appliance to the niche with 4 screws. I 7. Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B).
8. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb Hc 11. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 8 mm Hd 9.
Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. Hb Hd Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
Service Consommateurs De Dietrich BP 9526 95069 CERGY PONTOISE CEDEX Tel : +33 (0) 892 02 88 04 *0,34 Eur TTC / min à partir d’un poste fixe • Service fourni par FagorBrandt SAS, locataire-gérant, Etablissement de Cergy, • 5/7 avenue des Béthunes, 95 310 Saint Ouen L’Aumône www.dedietrich-electromenager.
FagorBrandt SAS, locataire-gérant - SAS au capital social de 20 000 000 euros RCS Nanterre 440 303 196.
