DOUBLE SIDE BURNER/GRIDDLE GDSBE1 models USER GUIDE US CA
! DANGER IF YOU SMELL GAS • Shut off gas to the appliance. • Extinguish any open flame. • Open lid. • If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. ! WARNING • Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance. • An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
CONTENTS Introduction 3 Safety and warnings 4 Before you begin 9 Lighting instructions | Side burner 10 Lighting instructions | Griddle 12 Leak testing 14 Low flame adjustment 16 Care and cleaning 17 Troubleshooting 18 Warranty and service 19 1
INTRODUCTION Bringing the precise control of your indoor cooktop to your outdoor cooking area, the dedicated double side burner lets you simmer your famous BBQ sauce while the ribs are grilling. With 17,000 BTU per burner designed for precise temperature adjustments, you can quickly go from a simmer to a boil, or anywhere in between.
SAFETY AND WARNINGS ! WARNING! Electric Shock Hazard Failure to follow this advice may result in electric shock or death. • This appliance is equipped with a three-prong or four-prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded power outlet. • Never remove the grounding plug or use with a 2 prong adapter.
SAFETY AND WARNINGS ! WARNING! Hot Surface Hazard Failure to follow this advice may result in fire, burns, scalds or personal injury. • Accessible parts may become hot during use. • When in use, do not touch the burner, grate, or immediate surrounding area as these areas become extremely hot. Clean the with caution. • Never let clothing or other flammable materials come in contact with or get too close to any grate, burner or hot surface until it has cooled. • Never lean over an open unit.
SAFETY AND WARNINGS ! WARNING! Explosion Hazard Failure to follow this advice may result in injury or death • If you smell gas, do not use the appliance. • Do not use water on grease fires, a violent steam explosion may result. Turn all burners off, then smother fire or flame or use dry chemical or foam-type extinguisher. • Do not heat unopened food containers such as cans – build up of pressure may cause container to burst and result in injury.
SAFETY AND WARNINGS zz zz Do not store a full LP tank in direct sunlight. After a period of storage or non-use, the appliance should be checked for gas leaks, deterioration, proper assembly, and burner obstructions before use. General Use zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz This appliance is not intended to be installed in or on recreational vehicles, trailers or boats. After lighting burners, ensure they are operating correctly.
SAFETY AND WARNINGS Gas requirements zz zz zz zz zz zz zz zz zz zz zz zz zz zz zz 8 This appliance can be used with any brand of 20lb LP gas tank provided it is compatible with a proper retention device (not supplied). The LP gas cylinder must be: zz Designed for use with a Type 1 system only. zz Constructed and marked in accordance with the Specifications for LP gas Cylinders of the U.S. Department of Transportation (D.O.T.
BEFORE YOU BEGIN zz zz zz Ensure the installer has completed the final checklist in the installation instructions. Read this guide, taking special note of the Safety and warnings section. Remove all packaging and dispose of it responsibly. Recycle items that you can.
LIGHTING INSTRUCTIONS | SIDE BURNER If you are using propane gas, a slight pop or flash may occur at the burner ports a few seconds after the burner has been turned OFF. This is normal for propane gas. 1 Remove the covers and any cooking utensils. 2 Push in and hold the selected dial for 2 seconds before turning to HI. Hold for 5 seconds to light the selected burner. 3 If burner does not light in 5 seconds, turn dial back to OFF and wait 5 minutes before trying again.
LIGHTING INSTRUCTIONS | SIDE BURNER Manual lighting If the burner will not light after several attempts, the burner can be manually lit. If you have attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. 1 Remove the covers and any cooking utensils. Ensure the drip pan is in place. 2 Using a match extension rod, carefully light a match and hold it near the desired burner port. 3 Turn the control dial counter-clockwise to HI.
LIGHTING INSTRUCTIONS | GRIDDLE The griddle burner is equipped with a thermocouple and safety valve system which monitors the burner. This will turn the gas off if the burner isn’t lit. 1 Remove the covers and any cooking utensils. Ensure the drip pan is in place. 2 Push in and hold the selected dial for 2 seconds before turning to HI. Hold for 10 seconds to light the griddle. 3 If burner does not light after several attempts turn the dial to OFF and refer to the troubleshooting section.
LIGHTING INSTRUCTIONS | GRIDDLE Manual lighting If the burner will not light after several attempts, the burner can be manually lit. If you have attempted to light the burner with the ignition, allow 5 minutes for any accumulated gas to dissipate. 1 Remove the covers and any cooking utensils. Ensure the drip pan is in place. 2 Using a match extension rod, carefully light a match and hold up against the base of the flash tube as shown. 3 Turn the control dial counter-clockwise to HI.
LEAK TESTING A complete gas tightness check must be performed at the installation site. Periodically check the whole system for leaks, or immediately if the smell of gas is present. Removing the valve panel 1 Remove all dials by pulling outwards. 2 Remove the 2 screws securing the valve panel to the unit using a Phillips screwdriver. 3 Pull the valve panel down then outward and unplug any wires.
LEAK TESTING Testing for leaks Prepare soap solution by combining one part liquid detergent and one part water. Pour into a spray bottle. Ensure all control valves are in the OFF position before turning the gas supply ON. 1 leak points leak points NG: 2 leak points Check all connections from the supply line or LP cylinder by applying the solution around the connection, tubing and end of the manifold. Soap bubbles will appear where a leak is present.
LOW FLAME ADJUSTMENT The valves on the double side burner/griddle unit feature an adjustable low setting. Due to fluctuations in gas pressure, or heating value you may feel it necessary to increase or decrease gas flow in the low position. If the gas type has been converted from natural to LP or vice-versa, the low flame setting must be reviewed and adjusted. 1 Push in and hold the selected dial for 2 seconds before turning to HI. Hold for 10 seconds to light the selected burner.
CARE AND CLEANING Stainless steel Always use the mildest cleaning method first. Do not use steel wool to clean the product as it will scratch the surface. Burner grates For durability and optimal performance, the side burner grates are crafted using porcelain enamel over cast iron. It is recommended that the grates are cleaned while in place, however if removing the grates take care as they are heavy and ensure they are placed on a protected surface. Grates can be cleaned using hot soapy water.
TROUBLESHOOTING 18 PROBLEM POSSIBLE CAUSES WHAT TO DO The burner won't light when the ignition is pushed There is no gas flowing to the unit. Check gas supply and connections. Ensure no air is trapped in line. There is a something blocking the air or gas flow. Check all openings for blockages. Burner flame is yellow or orange in conjunction with the odor of gas. Dirt or dust may be present in the area. Move to a less dusty area and check for obstructions. incorrect gas supply or type.
WARRANTY AND SERVICE Before you call for service or assistance Refer to the installation instructions and your user guide and check that: zz zz zz zz zz zz Your product is correctly installed. You are familiar with its normal operation. Model number (can be found on the inside, right side panel behind the drip pan handle. Serial number (can be found on the inside, right side panel behind the drip pan handle. Code (can be found on the inside, right side panel behind the drip pan handle.
DCSAPPLIANCES.COM © Fisher & Paykel Appliances 2019. All rights reserved. The product specifications in this document apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available. US CA 592075A 11.
