Installation manual

11
4. Using an adjustable wrench or 1/2" wrench, tighten the nuts.
5. Place the second U-bolt around the pole and through the two holes at the bottom of the
shelter.
6. Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten the hex
nuts so that the Yagi remains in place, but can still be adjusted.
7. Rotate the Yagi so that is points to the desired station/repeater/receiver.
8. Tighten the hex nuts so that the Yagi is firmly attached.
9. Rotate the second Yagi so that is points to the desired station/repeater/receiver.
10.While holding the Yagi antenna in the correct alignment against the pole, place a U-
bolt around the pole and through the two holes at the top and of the antenna plate.
11.Place a flat washer, a lock washer and a hex nut on each of the bolt ends.
12.Using an adjustable wrench or 1/2" wrench, tighten the nuts.
13.Place the second U-bolt around the pole and through the two holes at the bottom of the
shelter.
Installing a Repeater on a Pole
Refer to the following illustrations to install the repeater and antennas on a pole:
1. Place the repeater enclosure
on the pole somewhere
below the antennas that
makes it easy for the antenna
cables to be routed around. It
should below the second
antenna.
2. Mount a repeater enclosure
so that the solar panel
receives the maximum
amount of sunshine avail-
able at that location.
3. While holding the shelter
against the pole close to the
bottom, place a U-bolt
around the pole and through
the two holes on at the top of
the shelter.
4. Place a flat washer, a lock
washer and a hex nut on
each of the bolt ends.
5. Using an adjustable wrench
or 7/16" wrench, tighten the
nuts.
6. Place the second U-bolt
around the pole and through the two holes at the bottom of the shelter.
7. Put a flat washer, a lock washer, and a hex nut on each bolt end, and tighten the hex
nuts.
Flat
Washer
Lock
Washer
Hex
Nut
U-Bolt