User Guide

RKM-572 Holder

Instruction Manual

ccessories included:

• Screws (16 pcs)

10-32 x 5/8”

Hex drive

• Nylon Washers (16 pcs)

• Nylock Nuts (8 pcs)

10-32 thread insert size

• Tinnerman Clips (8 pcs)

10-32 thread insert size

Tools required:

• Crescent wrench or 3/8 wrench

• 1/8 Hex Key (1 pc) (included)

www.datavideo.us

PAGE 1
RKM-572 Holder Instruction Manual Accessories included: • • • • Screws (16 pcs) 10-32 x 5/8” Hex drive Nylon Washers (16 pcs) Nylock Nuts (8 pcs) 10-32 thread insert size Tinnerman Clips (8 pcs) 10-32 thread insert size Tools required: • Crescent wrench or 3/8 wrench • 1/8 Hex Key (1 pc) (included) www.datavideo.
PAGE 2
Holder Assembly Step 1: Lay the base flat on a hard surface. Step 2: Place the side bar vertically on top of the base (outer placement). Step 3: Place the washer onto the screw, and insert the screw through all 8 bottom holes, securing the screws with nylock nuts. Step 4: Repeat steps 2 and 3 for the second side bar. Mounting Unit Step 5: Slide the tinnerman clips onto the sidebar over the holes. Step 6: Place the monitor on top of the tinnerman clips.