Operation Manual

Setup

PowerScan™ PD9530/PBT9500/PM9500

To change the Bracket:

1. Remove the screw holding the Bracket in place. Retain the screw for re-

use.

2. Carefully lift off the Bracket.

3. Install the other bracket by first slipping the end tab into place on the

base station, then easing the tabs (shown in Figure 1 on page 9) into

place on the sides.

4. Replace the screw to secure the Bracket to the Base Station.

Figure 2. Changing the Bracket

Permanent Mounting

For either desktop or wall mounting, the cradle can be fastened directly to a

flat surface using screws (not included).

When mounting on drywall, the base should be screwed to a wall stud or

supporting beam for additional support.

Figure 3. Base Station Bottom

Mounting

Protective Adhesive

Rubber Feet

Strips

Holes