Instructions / Assembly

ManualsBrandsDANCO ManualsPlumbingToilet Tank Lever Replacement Handle in Brushed Nickel

Figure A Figure B Figure C

Image I

2. REFER TO TABLE 1 ON PAGE 1 TO DETERMINE IF YOUR REPLACEMENT INVOLVES A LEFT FRONT, RIGHT FRONT, SIDE, OR ANGLED HANDLE PLACEMENT.

1. Remove existing handle

and arm. Loosen locknut

and pull entire arm

out through tank hole.

FOR RIGHT SIDE VERTICAL TOILETS:

RIGHT SIDE VERTICAL (PLASTIC HANDLE)

3. Remove arm from packaging. Refer to Image I for how to hold the handle. Do not push red button marked X in Image I at this time.

*Image shows Straight Lever Handle Style

Handle (A)

Locknut (C)

Red Button (E)

Lever Arm (D)

Lever Mount (B)

Use for Steps 4

Image II

Image IV

Use for Step 7

Image V

Use for Step 7

Image VIIIImage VII

Image VI

Use Image IV and Image V for step 7

7. Position lever arm (D) perpendicular (90° Degrees)

to handle and slide back onto lever mount (B) using

arrows to align with notches; then twist to lock

in place. Lever arm (D) will be upside down with red

button pointing down when finished

Use Image III for steps 5 through 6

5. Insert lever mount (B) through tank hole with

the handle facing down while ensuring the T1

mark on the hub of the lever mount is facing up.

6. Reattach locknut (C) back onto lever mount (B)

clockwise finger tight, ensuring locknut is

facing flat side toward handle.

Use Image II for step 4

4. Hold the handle in one hand, grab the

threaded hub portion of the Lever Mount (B)

with the other hand and pull apart (1),

compressing the spring at the end. Then

rotate the threaded hub 90 degrees (2)

until T1 faces up in the orientation it will be

installed in the tank. Release the threaded

hub, ensuring it seats fully back into the

handle.

8. For angle adjustment (Image VI) inside toilet, push up on red button (E) and lower lever arm (D) to adjust angle left or right and align

placement prior to connecting flapper chain.

9. For lever arm (D) height adjustment inside toilet (Image VII), push in toward lever mount (B) and rotate up or down.

10. Attach chain (Images VII and VIII). Chain needs ½" slack with flapper closed. Arm cannot hit tank cover.

Hub of Lever

Mount (B)

Use for Steps 5 through 6

Image III