Installation Guide

ROUGH-IN INSTALLATION

Installation Instructions For

Pull Stop Box

™

2. Attach supply line to valve inlet via pipe manufacturer’s recom-

mended practice (i.e. sweat for copper, solvent cement for CPVC,

crimp rings for PEX).

1. Identify desired outlet location.

3. Fasten Pull Stop Box using two screws or two nails into

a stud or thread a hyco strap through the mounting bracket slot

and secure with a screw. (Do not over tighten screws or over

drive nails.)

4. Pull Stop Box arrives in the off position. Once box is securely

attached to wall and the supply line is properly attached, no

further work is necessary during the rough-in phase. The

included protective cover will protect the valve during the

construction process.

TRIM KIT INSTALLATION

1. Remove protective cover by pulling away from wall. 2. Feed a flexible connector through escutcheon. It may be

helpful to first attach supply line to the fixture.

PAGE 1
Installation Instructions For Pull Stop Box ™ ROUGH-IN INSTALLATION 1. Identify desired outlet location. 3. Fasten Pull Stop Box using two screws or two nails into a stud or thread a hyco strap through the mounting bracket slot and secure with a screw. (Do not over tighten screws or over drive nails.) 2. Attach supply line to valve inlet via pipe manufacturer’s recommended practice (i.e. sweat for copper, solvent cement for CPVC, crimp rings for PEX). 4. Pull Stop Box arrives in the off position.
PAGE 2
Installation Instructions For Pull Stop Box ™ TRIM KIT INSTALLATION (Continued) 3. Thread flexible supply line onto valve outlet and tighten to manufacturer’s specifications. 4. Swing threaded metal arm on the valve out until it is perpendicular to the wall. 5. Line up square hole in escutcheon with threaded metal arm and push the escutcheon into the Pull Stop Box. Make sure to feed the threaded metal arm through square hole. 6. Thread knob onto threaded metal arm a minimum of four full turns. 7.