Owner's Manual

3
Printed in U.S.A. 93841 Rev. 12/08
Wall Switch
1. Using 3-conductor, 20-24 gauge wire, extend the wall switch wires from the back of the wall switch to the length
required to reach the VPI.
2. Connect the extended wires from the wall switch to the VPI wires that are labeled “wall switch”. Refer to Figure 4.
AC POWER CONNECTIONS
FIGURE 4
NOTE: 20-24 AWG WIRE RECOMMENDED FOR CONNECTING
WALL SWITCH TO VPI CONTROLLER
NOTE: 20-24 AWG WIRE RECOMMENDED FOR CONNECTING
WALL SWITCH TO VPI CONTROLLER
120V 240V
RED
BLACK
WHITE
DOWN
BACK OF
WALL SWITCH
FRONT OF
WALL SWITCH
STOP
UP
RED
BLACK
WHITE
DOWN
BACK OF
WALL SWITCH
FRONT OF
WALL SWITCH
STOP
UP