Owner's manual

24
1.Programs
1.1 Program Saving
1.2 Program Naming
1.3 Program Lock
A Program can be stored in any one of the 60 available memory locations. Pressing
displays the Save screen with the last used Program on the screen. Pressing either or
turning the rotary encoder enables the selection of the required memory for saving your new Program.
The Program can be given a name using alphanumeric characters up to 8 digits in length. To input a
new name, press the to move the cursor into the name area of the screen. The screen will display
the current name of the Program that is being edited ( after a short period of time), and the cursor will
locate under the first character to be modified. Characters can be changed using either the
buttons or the rotary encoder and the next character along can be selected using the button.
Use the button to go back to change or correct previously set characters.
Pressing a second time will perform the saving if the Program location is not locked.
User Programs can be locked to prevent overwriting of memories too easily. A store will fail if the
lock button character is displayed when is pressed. The 'Program Locked!' message
will stay on the screen for a few seconds. After this Message has disappeared the lock can be turned
off with either the button by turning the rotary encoder anticlockwise. The saving will now be
successful.
After the saving operation the DSP-26 asks whether the Program should be saved 'Locked' or 'Unlocked'.
Turning the rotary encoder will select between 'Locked' and 'Unlocked' , select your preference and
press a third time to complete the operation.
SAVE/ENTER
PREV/NEXT
PREV/
NEXT
SAVE/ENTER
SAVE/ENTER
NEXT
SAVE/ENTER
SAVE
1 MINISTRY
PROGRAM LOCKED!
1 PLASA
STORE UNLOCKED ?
LOCKED
STORE UNLOCKED ?
UNLOCKED
1.4 Program Recall
Pressing will enter the recall mode with the last used Program on the screen. Use the
buttons or the rotary encoder to select a Program to recall. Only Programs that have already
been stored will be available to choose from. There will always be at least one default Program in
existence in the unit's memory.
RECALL PREV/
NEXT
OPERATION
Manual del usuario/ User´s manual DSP-26