Installation Guide

2 doors
3 doors
4 doors
2 Installing Tracks
Top Track - Position Track into the top
of the opening. Drill and plug the
Track ( See overleaf for suggestions).
Floor Track - Position the Track 32mm
back from the front line of Top Track. Fix
the Floor Track using double sided tape
or screws.
IMPORTANT- Floor track should never
be raised on a plinth as this could lead
to doors leaving the tracks.
1 Sizing Tracks
Measure the width of the top of your
opening. Using a set square mark a
straight line across the Top Track A.
Measure the
width of the base of your
opening. Mark a corresponding line
tooth hacksaw.
3 Positioning Doors
Tip- If installing Panel doors in
combination with Mirror Doors it is
usual to locate the Panel Doors to
the back and Mirror Doors to the
front of the track.
4 Installing Doors
doors with the bottom of the door
slanting out at 15º. Lower bottom
wheels into bottom track before
engaging top guides.
5 Engaging Top Guide
Push up white plastic section of
the guide to engage into top track.
To remove door from top track
pull down on top guide as shown.
Guide will then disengage from
top track. Lift out a 15º angle.
6 Adjusting Doors
Align doors plumb to side walls. Adjust
bottom wheels to alter the height and
angle of each door. Using a pozidrive
screwdriver, correct door alignment
with screw adjuster attached to bottom
wheel. Turn the screw clockwise to
lower the door and anti-clockwise to
raise the door. Plumb doors to adjacent
walls and other doors by adjusting both
left and right wheels up and down as
required.
7 Engaging Anti-jump Clips
Clips must be engaged to ensure
doors do not leave tracks.
A Rotate anti-jump clip into open position
B Push antijump clip fully down into track
C Rotate Anti-jump clip back into
closed position
To disengage anti-jump clip-reverse
procedure.
(In the unlikely event of
anti-jump clip becoming detached
during angagement, simply snap it
back into original position
shown on drawing A).
INSTALLING STANDARD SLIDING DOORS
C
B
A