Owners manual

Parts List
DESCRIPTIONPART NUMBERQTYITEM
HANDLE NUT1/2-1321
FW, 12, ZPFW12
4
2
HEX BOLT1/2-13 x 1 1/4
23
LOCK WASHER1/2"24
.250 x 1.50 x 2.00" SQUARE HOLE SPACERCM-SP1
45
CARRIAGE BOLT1/2-13 x 1 1/4
46
HEX FLANGE NUTHFN 12134
7
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
WARNING: ALL NON-TRAILER LOADS APPLIED TO THIS PRODUCT MUST BE SUPPORTED BY AUXILIARY STABILIZING STRAPS.
** FAILURE TO PROPERLY SUPPORT NON-TRAILER LOADS WILL VOID PRODUCT WARRANTY**
HAVING INSTALLATION QUESTIONS? CALL TECHNICAL SUPPORT AT 1-800-798-0813
HITCH WEIGHT:
LBS.
INSTALL TIME
PROFESSIONAL: MINUTES
NOVICE (DIY): MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3500 350
40
45
97.5-08 BUICK REGAL, PONTIAC GRAND PRIX
9/10/2012
12225
90
36241
INCLUDING GT AND GTP
1) Detach (5) rubber exhaust hangers and lower rearward portion of exhaust system.
2) Insert carriage bolts and blocks in frame rails through access hole.
3) Raise hitch into position and check side to side clearance with frame. Tape 1/2" washers to hitch as necessary
to eliminate gap.
4) Raise hitch in to position and attach with carriage bolts as shown.
5) Using hitch as a template, drill two holes in side of frame rails.
6) Insert hex bolt and lock washer through side of frame rail and secure with handle nut inserted through end of
frame rail.
7) Reinstall exhaust system.
8) Torque all 1/2" fasteners to 110 lb.-ft.
6
5
7
3
4
2
1
DRILL HOLE
EACH SIDE
-DRILLING REQUIRED
-LOWER EXHAUST
DESIGNED FOR USE WITH
BALLMOUNT # D221 / 45522