Instructions / Assembly

MODEL#: AND9202MK
ASSEMBLY INSTRUCTIONS
WARNING:
Electrical Danger
Turn Power Off
2018-10-29
You will need 4 – Cand.Bulb
40 Watts Recommended
60 Watts Max
USE LED BULBS FOR EXTENDED USE
California T24 JA8-2016 Qualified: Satco
(S9612); 10.5 watt LED Cand Base
recommended. Bulb not included
95 Cantiague Rock Road , Westbury, NY 11590 • toll free: 1.800.888.4470 fax: [phone] • [e-mail] • www.crystorama.com
Assembly:
1. To install glass panels, separate the Bottom Cage (7) , by removing the Decorative Nut (5).
2. Bend glass Clip (6) and slide Glass (3) into the the Bottom Cage (7).
3. Bend glass Clip (6) to secure Glass (3) .
4. Install the bulb (4) to the socket (2).
5. Connect the Bottom Cage (7) and the Top Cage (1), by screwing in Decorative Nut (5) to secure cage.
6. The backplate of the fixture can now be mounted to the wall by following instruction Drawing 2.
Replacement Glass installation:
1 .Follow instructions # 1 through # 3 above to install new glass. Complete by connecting the Bottom Cage (7) and the Top Cage (1)
by screwing in Decorative Nut (5) to secure cage.
Bulb replacement:
1. Install the bulb (4) into the socket
After securing fixture to the wall it is
recommended that the gap between the wall and the backplate be sealed on
the top and both sides, with a good quality
waterproof caulk or silicone sealant (NOT INCLUDED)
LISTED
R
All electrical components must be
installed by a licensed electrician
in accordance with the National
Electric Code and the appropriate
local electrical codes.
WARNING: This product can expose you to Lead,
which is known to the State of California to cause cancer
and/or birth defects or reproductive harm. For more
information go to www.P65Warnings.ca.gov