Software User guide

Settings  8
Con gXP User’s Manual
—
UNITS BUTTON OPTIONS
Select the pressure units you need, and turn o the pressure units you never use (at least one unit must be selected).
Use the Unit button options to control which units the pressure gauge will display.
•
Default Unit: The pressure unit displayed after a reset, and the unit used when in datalogging mode. (Reset occurs when the batteries are changed, when an
!RST command is sent to the gauge over the serial port or, on older units, when the calibration settings are changed.)
•
Water Density: From the dropdown menu, select 4 °C (39.2 °F), 15.6 °C (60 °F), or 20 °C (68 °F). A ects inches of water (inH
2
O), only.
•
•
User De ned Units: This section allows you to create a custom pressure unit. When you select this unit the gauge will display USER. The display will equal
the User Factor multiplied by the measured psi plus the User O set. Use the Resolution dropdown menu to select the number of decimal places on the
displa
y. Con gXP automatically limits the maximum number of decimal places depending on the pressure range of the gauge, so that only valid numbers
can be displayed on the gauge.
•
•
•
•
•
•
•