Operator's Manual

24 Verifier
®
Sentry Operator Manual 870391 V1.4
IntroductionMaintenance
Remove the Micro SD card
Use the following procedure to remove the Micro SD card from the Sentry. The Micro SD card connector is in the floor
of the battery compartment, next to the battery contacts.
1 Remove the battery. See “Remove the battery” on page 21.
2 Use a fingertip to slide the Micro SD cover toward the Sentry label and unlock
the cover.
3 Open the cover.
4 Remove the Micro SD card.
5 Close and lock the cover on the Micro SD card connector.
6 Insert the battery. See “Install the battery” on page 22.
Find the Product Label
Use the following procedure to find the product label for the Sentry.
1 Remove the battery. See “Remove the battery” on page 21.
2 The product label is visible in the battery compartment near the two SAM card connectors.
3 Insert the battery. See “Install the battery” on page 22.
Replace the fingerprint sensor
If the fingerprint sensor must be changed, Crossmatch provides a Sensor Replacement kit. The part number of the kit is
8880125-001. The kit includes a sensor, a special tool and complete instructions to replace the sensor.