Operator's Manual

21
Maintenance
THIS DOCUMENT DESCRIBES THE MAINTENANCE THAT THE OPERATOR CAN PERFORM ON THE SENTRY.
Figure 7 The Sentry battery compartment (battery removed)
Remove the battery
Use the following procedure to remove the battery.
1 Press and hold the Start switch to turn off the Sentry.
2 Hold the Sentry with the back of the device visible.
3 Loosen the hand strap.
4 Slide and hold the latch for the cover in the open position.
5 Apply enough pressure to slide the cover away from the latch until it stops.
6 Release the latch and lift the cover from the Sentry.
7 Lift the bottom of the battery and remove the battery from the battery compartment.
Table 13 Items in the Sentry battery compartment
1
The cover latch for the battery compartment. The latch slides to release the cover. The latch automatically returns to
the closed position.
2
The socket for the SIM card accepts a normal size SIM card (recommended). An adapter tray is required for smaller
SIM cards.
3
The latch that indicates that the battery is installed. The battery compresses the latch and the installation is
recorded in the log. When the battery is removed, the latch is released and the removal of the battery is recorded.
4
The socket for a SAM card. There are two sockets.
5
The product label for the Sentry.
6
The Micro SD card socket.
7
The battery connection points for the Sentry.
2
3
1
7
6
4
5