Use and Care

Icemaker Installation
Fix the Water tube to the refrigerator
Route and attach the plastic water line
Install the water valve
Male
terminals
Phillips head
screw
Prepare for Installation
but do not screw them all the way out. If your model
does not have the screws already in the freezer wall,
look for two plug buttons. Remove the plug buttons
and insert the two phillips head screws. The screws
should extend approximately 1/2 ″ (13mm) out from
the freezer wall.
Set feeler arm to Stop position.
Move the feeler arm to the STOP (up) position
until the refrigerator is connected to the water
supply to prevent premature operation.
Hole for
wire tie
(Appearance may vary)
Mounting
screws
Inside the freezer, loosen the two moungting screws,
Install the Icemaker Fill Cup
Install the icemaker fill cup (side-mounted) into the
icemaker as shown.
S
TO
P
Feeler arm in the STOP
(up) position.
Feeler arm in ON (down)
position.
Icemaker
fill cup
ST
O
P
Hold the Guide Cab W / Tube A1 and insert the Guide
Then cover the previous assembly with the Cover
Cab W / Tube A2 connector onto the entrance on the
flat part.
Guide Cab W / Tube, ensuring that it fits correctly
into the guides on the flat side of the Guide
Cab W / Tube A1.
Insert and slide the tube over
the center hole at the top, at
the back of the refrigerator.
Press the same one firmly on
the entrance so that it is
adjusted to the refrigerator.
Attach the water valve to the cabinet by inserting
the T1 4x14 mm Phillips head screw from the kit
into the hole in the base of the cabinet.
Press the Guide Cab W / Tube A1 assembly as
soon as it is inserted into the back of the
refrigerator.Insert the screws into the holes in the
Cover Guide Cab using the T1 4x16 mm
screws.Keep the fixed pipe by applying cotton tape
over the plastic pipe, approximately 1 1/2 (40mm)
Tape Cotton
Screw
T1 4x16
Attach the plastic water pipe to the back of the
cabinet with the cotton adhesive tape, separating
as shown to tighten the pipe.
Cotton adhesive
Tape
Locate the male connector plug on the valve.
Locate and insert the female connector on the
bottom of the refrigerator. Observe the correct
way to connect both connectors.
Female
connector
1833
á