Instructions / Assembly

English

Turntable Maintenance

1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the

turntable mat or a record’s edge.

2. Clean the stylus frequently with a soft brush with a back-to-front motion only.

3. Clean the records to get rid of dust or grease with a record cleaning brush

and record cleaning solution.

4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber

cloth.

Note: Do not use cleaners that contain alcohol, benzene, or any other harsh chemicals

that might damage the paint and finish of the turntable.

Troubleshooting

There is no power

 Power adaptor is not connected correctly.

 No power at the power outlet.

 To help save power consumption, some models will comply with ERP energy

saving standard. When there is no audio input for 20 minutes, their powers

will automatically cut-off. To turn power back on and resume playing, turn off

the power and turn it on again.

Power is on, but the platter does not turn

 Turntable’s drive belt has slipped off.

 An aux in cable is plugged into the aux in jack, unplug it.

Turntable is spinning, but there is no sound, or sound not loud enough

 Stylus protector is still on.

 Tone arm is lift up by the lever.

 Headphone is plugged in.

FCC Statements

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into a circuit different from that to which the receiver is connected.

 Consult the dealer or an experienced radio TV technician for help.