PART LIST Top Panel Left Panel Right Panel Bottom Panel Rail 1PC 1PC 1PC 1PC 1PC Back Panel Left Door Panel | Right Door Panel | Adjustable Shelf | Drawer Front Panel 1PC 1PC 1PC 1PC 1PC Drawer Left Panel| Drawer Right Drawer Back Drawer Bottom Drawer Split Panel Panel Panel Panel 1PC 1PC 1PC 1PC 1PC
HARDWARE LIST Rescuer =S == == $1/4" $8x30mm $6x30mm Short Bolt Spring Washer Flat Washer Large Wood Wood Dowel Dowel 10 PCS (Extra 1) | 10 PCS (Extra 1) | 10 PCS (Extra 1) 8 PCS PCS $8x1" $3x14mm $3x14mm Long Screw Magnet Round Head Shelf Holder Screw Screw 10 PCS (Extra 1) 1PC PCS 4 PCS (Extra 1) | 23 PCS (Extra $5/32x15mm Large Handle Handle Round Head Allen Wrench | Safety Strap Kit Bolt 1PC PCS 6 PCS 1PC 1 SET ADDITIONAL TOOLS (Not Provided) Note: It is not recommended to use power tools during assembl
Step 1. Attach handles (parts #11 & #12) to door panels (parts G & H) and drawer front panel (part J) using round head bolts (part #13) and fillips head screwdriver. Attach magnet (part #7) to rail (part E) using round head screws (part #8) and fillips head screwdriver. using long screws (part #6) and fillips head screwdriver. Attach drawer panels (parts drawer back panel (part M} using long screws (part #6) and fillips head screwdriver.
Step 3. Attach rail (part E) and bottom panel (part D) to panels (parts B & C) using large wood dowels (part #4), short bolts (part #1), spring washers (part #2), flat washers (part #3) and Allen wrench (part #14). #14x1 Step 4. Attach top panel (part A) to panels (parts B & C) using large wood dowels (part #4), short bolts (part #1), spring washers (part #2), flat washers (part #3) and Allen wrench (part #14).
Step 5. Attach back panel (part F) to assembled unit (parts using screws (part #10) and fillips head screwdriver. #10 e x21 Step 6. Carefully turn unit upright. Place shelf holders (part #9) into desired position and slide adjustable shelf (part 1) into place.
Step 7. Attach door panels (parts placing bottom pin hinge (preinstalled in door) in the per-drilled hole of bottom panel (part D). Then depress the top spring-loaded pin hinge so it can be placed in the per-drilled hole of rail (part E). Note: Be sure top and bottom pin hinges are fully extended to secure doors in place. Step 8. Slide assembled drawer into place. Important: Safety strap kit (part #15) must be installed to prevent tipping, damage and/or injury.
5/8"x #3xD8 $4xD8 Safety Strap | Wall Anchor Bracket Short Screw | Long Screw | Safety Wall Kit Strap 18ET 1PC PCS 1PC 1PC 1PC SAFETY WALL STRAP INSTALLATION Note: It is highly recommended to install this safety strap kit to prevent tipping, damage and/or injury. 1. Insert short screw (C) and safety wall strap (E) through bracket (B) and attach to top panel (part A} using fillips head screwdriver. 2. Drill a 11/32" hole where you want to secure the unit.