Installation Instructions

29
11. Locate latch lever in hardware package and
insert its tail into the escutcheon plate with lever
pointing toward the stationary panel (FIGURE 11).
Arrange tail of latch so locking mechanism (latch or
shoot bolts) will activate when the latch handle is
pushed down.
12. Locate the interior handle and two color-
matched Phillips, flat head, machine, set screws
(FIGURE 12).
13. Insert pins on back of interior handle into
escutcheon plate. (FIGURE 12) shows compo-
nents unmounted for clarity.
NOTE: Arrange screw holes in handle and
escutcheon plate as shown so set screw
can be installed.
14. While holding handle tight to escutcheon plate,
insert set screw through escutcheon plate and into
handle (FIGURE 13). Tighten screw loosely. Insert
second set screw into escutcheon plate.
15. Tighten both screws securely.
16. Install the second interior handle on the other
active panel following Steps 11 through 15 above.
(FIGURE 14) shows an interior view of the com-
pleted handle installation.
NOTE: The door latch mechanism, door latch
keeper and shoot bolt system are pre-
installed on the 4-Wide door.
FIGURE 11
INTERIOR
HANDLE
ESCUTCHEON
PLATE
SET
SCREW
FIGURE 12
FIGURE 13
FIGURE 14
Handle Installation – 4-Wide Door (cont.)