Assembly Instruction

Made in China r08 Page 2 of 3
3 Insert 6 cams into the bottom panel as shown. Make
sure the arrow on each cam points towards the nearest edge
with holes.
4 Fit cam screws & dowels of front and back panel into
corresponding holes in the bottom panel. Secure 6 cams on
the bottom panel with a phillips head screwdriver. Turn
each cam clockwise until it securely engages each cam
screw.
LOOP STORAGE BENCH
1 A) Place back panel face up on a padded surface as
shown. Insert 2 wood dowels, 3 cam screws, and 4
cams into the holes as shown. Secure each cam screw,
but do not over tighten with a phillips head screwdriver.
Make sure the arrow on each cam points towards the
nearest edge with holes.
B) Insert 2 wood dowels, 3 cam screws, and 4 cams into
the front panel.
2 Insert 4 wood dowels and 4 cam screws into each side
panel as shown.
A
B
Arrow on each
cam points towards
nearest edge
with holes
Cam in
unlocked
position
Cam in
locked
position
Back Panel
Front Panel
Customer Service 800.967.6696 | www.crateandbarrel.com