Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
x 20
A
B
FLEX DESK
Page 2 of 2
Made in Taiwan - r03
2 Fit brackets of front frame into ends of crossbars.
Secure each crossbar with 2 bolts, fully tightening with the
allen wrench. At this point, fully tighten 10 bolts installed
in Step 1 with the allen wrench.
4 With the assistance of another adult, fit return assembly
underneath desk assembly, aligning hole in pivot crossbar
with hole in underside of front frame. Attach with 1 long
bolt and 1 flat washer, securing with the allen wrench.
3 A. Fit 2 return crossbars and 1 pivot crossbar onto
corresponding brackets on the right and left return frames
as shown. Secure with 4 short bolts per crossbar, fully
tightening each with the allen wrench.
B. Insert 1 caster and 1 split washer into the bottom of
one leg. In the other leg insert 1 locking caster and 1 split
washer. Secure by turning each caster clockwise with the
hex wrench until tight.
CLEANING AND CARE
Clean surfaces with a dry or damp soft cloth. Do not use
abrasive cleaners.
5 A. Adhere 10 rubber bumpers onto the crossbars as
illustrated above.
B. Carefully place desktop glass and return glass into
their respective positions, making sure each is firmly and
evenly supported by the bumpers.
Assembly is now complete.
A
B
IMPORTANT NOTE:
Make sure pivot shaft
faces up as shown