Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com
Made in Denmark r04 Page 2 of 3
4 Fit back panel onto cam screws of side panel as shown.
Make sure cams of back panel face “back” as illustrated.
5 Using a phillips head screwdriver, turn bottom 2 cams
of back panel clockwise until each cam fully engages each
cam screw.
CHECKERS DOUBLE SHELVING
2 A) Insert 2 cam screws into each side panel as shown.
Secure, but do not over tighten each cam screw with a
phillips head screwdriver.
B) Fasten 4 cam screws to the 2 end panels with a phillips
head screwdriver.
3 Insert 4 cams into the large holes of the back panel as
shown. Make sure the arrows on each cam point out towards
the nearest edge with holes.
NOTE:
Do not over
tighten the
cam screws
End Panels
Side Panels
A
B
Back Panel
Arrow on
each cam
points towards
nearest edge
with holes
Cam in
unlocked
position
Cam in
locked
position
Customer Service 800.967.6696 | www.crateandbarrel.com