Assembly Instruction

Made in Vietnam - r02 Page 5 of 5
BRIGHTON CHIFFOROBE
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
A
C
small
screw
wall
bracket
plastic
anchor
large
screw
wall
strap
D
F
wall
bracket
12 Safety Mounting Instructions
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs
whenever possible.
A) Locate pilot holes on back of unit and attach wall
bracket using 2 small screws as shown.
B) Determine the final location of unit. Mark position on the
wall, approximately 2" below the wall bracket mounted to
the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap the plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach wall bracket to the wall by inserting 2 large
screws into the plastic anchor in the wall.
E) Place the unit so the wall brackets on the back edge are
aligned with the wall brackets on the wall.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.
H) Repeat steps A-G for remaining wall brackets and wall
straps.
Wall mounting assembly is now complete.
NOTE:
If you are unsure about your wall type or
what mounting method you should use,
consult a qualified professional or your
local hardware store.