Owner's Manual

ManualsBrandsCraftsman ManualsBatteries and ChargersCraftsman C3 19.2 Volt Replacement Batteries (2 pk.)

Battery Packs

Item Nos.

11068 (12 Volt)

11044 (14.4 Volt)

11045 (18 Volt)

11375 (19.2 Volt)

CHARGER SOLD SEPARATELY

Always mention the above item numbers when communi-

cating with us regarding battery packs.

Use battery packs for Craftsman Cordless products only.

Refer to the Operator’s Manual provided with product.

These battery packs require 1 hour of charging time to be

fully charged.

Use batteries only with chargers listed.

MODEL NO. BATTERY PACK CHARGER

315.110680

130279001

Item No.

11068

1425301

Item No.

11041

315.110441 130279002

Item No.

11044

1425301

Item No.

11041

315.110451 130279004

Item No.

11045

1425301

Item No.

11041

315.113753 130279003, 130279005

Item No.

11375

1425301

Item No.

11041

Batteries vent hydrogen gas and can explode in the

presence of a source of ignition, such as a pilot light.

To reduce the risk of serious personal injury, never use

any cordless product in the presence of open flame. An

exploded battery can propel debris and chemicals. If

exposed, flush with water immediately.

Do not charge battery in a damp or wet location.

Following this rule will reduce the risk of electric shock.

For best results, your battery should be charged in a

location where the temperature is more than 50°F but

less than 100°F. Do not store outside or in vehicles.

Save these instructions. Refer to them frequently

and use them to instruct others who may use this

tool. If you loan someone this tool, loan them these in-

structions also to prevent misuse of the product and

possible injury.

WARNING! Read all instructions. Failure to follow

all instructions listed below may result in electric

shock, fire and/or serious injury. The term “power

tool” in all of the warnings listed below refers to your

mains-operated (corded) power tool or battery-oper-

ated (cordless) power tool.

Ensure the switch is in the off position before inserting

battery pack. Inserting the battery pack into power tools

that have the switch on invites accidents.

Recharge only with the charger specified by the manu-

facturer. A charger that is suitable for one type of battery

pack may create a risk of fire when used with another bat-

tery pack.

Use power tools only with specifically designated bat-

tery packs. Use of any other battery packs may create a

risk of injury and fire.

Do not place battery tools or their batteries near fire

or heat. This will reduce the risk of explosion and possibly

injury.

 Never use a battery that has been dropped or

received a sharp blow. A damaged battery is subject to

explosion. Properly dispose of a dropped or damaged

battery immediately.

When battery pack is not in use, keep it away from

other metal objects like paper clips, coins, keys, nails,

screws, or other small metal objects that can make a

connection from one terminal to another. Shorting the

battery terminals together may cause burns or a fire.

Under abusive conditions, liquid may be ejected from

the battery, avoid contact. If contact accidentally oc-

curs, flush with water. If liquid contacts eyes, addition-

ally seek medical help. Liquid ejected from the battery

may cause irritation or burns.

CHARGING THE BATTERY PACK

Battery packs are shipped in a low charge condition to

prevent possible problems. Therefore, you should charge it

until the green LED on the front of the charger comes on.

NOTE: Batteries will not reach full charge the first time they

are charged. Allow several cycles (operation followed by

recharging) for them to become fully charged.

CHARGING A COOL BATTERY PACK

If battery pack is below normal temperature range, the green

LED on charger will come on. Allow battery pack to reach

normal temperature, then the red LED will come on.

NOTE: If the charger does not charge the battery pack

under normal circumstances, return both the battery pack

and charger to your nearest authorized service center for

electrical check.

 Charge the battery pack only with the charger provided.

 Make sure the power supply is normal household

voltage, 120 volts, 60 Hz, AC only.

 Connect the charger to the power supply.

 Place the battery pack in the charger aligning raised rib

on the battery pack with the groove in the charger. See

Figure 1.

 Press down on the battery pack to be sure contacts on

the battery pack engage properly with contacts in the

charger.

 Normally the red LED on charger will come on. This

indicates the charger is in fast charging mode.

SAFETY RULES

OPERATION

Summary of content (4 pages)

PAGE 1
 Use batteries only with chargers listed. Battery Packs Item Nos. 9 11068 (12 Volt) 9 11044 (14.4 Volt) 9 11045 (18 Volt) 9 11375 (19.2 Volt) CHARGER SOLD SEPARATELY Always mention the above item numbers when communicating with us regarding battery packs. Use battery packs for Craftsman Cordless products only. Refer to the Operator’s Manual provided with product. These battery packs require 1 hour of charging time to be fully charged. SAFETY RULES WARNING! Read all instructions.
PAGE 2
operation BATTERY PACK 11375 IN CHARGER 11041 CHARGER Red LED ® NOTE: The green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply.  If both yellow and green LEDs come on, this indicates a deeply discharged or defective battery pack. Allow the battery pack to remain in the charger for 15 to 30 minutes. When the battery pack reaches normal voltage range, the red LED should come on.
PAGE 3
 Cargue las pilas solamente con los cargadores indicados. núm. modelo PAQUETE DE PILAS CARGADOR 315.110680 130279001 Art. no. 9 11068 1425301 Art. no. 9 11041 Paquetes de pilas 315.110441 130279002 Art. no. 9 11044 1425301 Art. no. 9 11041 Números de artículos 9 11068 (12 volts) 9 11044 (14,4 volts) 9 11045 (18 volts) 9 11375 (19,2 volts) 315.110451 130279004 Art. no. 9 11045 1425301 Art. no. 9 11041 315.113753 130279003, 130279005 Art. no. 9 11375 1425301 Art. no.
PAGE 4
Funcionamiento PAQUETE DE PILAS 11375 EN EL CARGADOR 11041 CONJUNTO DE CARGADOR DIODO ROJO ® NOTA: El diodo luminiscente verde permanece encendido hasta que se retira el paquete de pilas del cargador o éste se desconecta del suministro de corriente.  Si se encienden ambos diodos luminiscentes, el amarillo y el verde, esto indica que el paquete de pilas está sumamente descargado o defectuoso. Permita que el paquete de pilas permanezca en el cargador de 15 a 30 minutos.