Manual

B. OPERATING TIPS
&, WARNING 1
Do not use the unit without the blower tubes[
properly attached to avmd flying debris and]or|
impeller contact which can cause serious injur_ /
1. Always work going away from solid objects
such as wails, large stones, automobiles and
fences,
2. Do not operate unit at full throttle when
cleaning in corners. Clean corners by starting
in corners and moving outward to straight areas
to prevent an accumulation of debris which could
fly into face,
3. Be careful when working near plants. The
force of' the air could damage tender plants
4. Direct air flow by directing the nozzle dowu or
to one side.
5. Vary the air flow by turning the Throttle Knob
to the desired setting. Use low speed when blow-
ing in corners, against walls, around tender
plants, in extremely dusty areas, etc Use high
speed when blowing in open areas,
A WARNING
Always wear eye protection to prevent rocks or I
debms from being blown or rmocheting into the
eyes .mad.face which can result in blindness or se-
[rious i_lur_.
6. Use the assist handle located on the back ofthe
u_fit when working above the waist or when a
two-handed gripis desired.
7. Uses For Your Blower:
a. Sweeping debris or grass clippings fi'om drive-
ways, sidewalks, patios, parks, parking lots,
barns, stadiums, etc.
b. Blowing grass clippings, straw, or leaves into
piles_
c. Fast drying wet outdoor areas such as a patio.
d. Removing debris f_om corners, around joints,
and between bricks.
e. Blowing light snow from driveways, sidewalks,
or patios.
C. PRE-OPERATION CHECKS
Before operating your unit, always:
1. _'CHECK OVER WARNINGS AND SAFETY
INSTRUCTIONS in this Operator's Manuai.
Make certain you completely understand and fol-
low each one.
2. v'CHECK THE AIR FILTER.
Clean the filter if dirty before operating the unit.
For location, see the "Air Filter" section.
3. _'CHECK THE UNIT FOR LOOSE BOLTS,
NUTS, OR FITTINGS.
Tighten, repair, or replace parts as necess.ary. You
will need a Phillips screwdriver and a 5/32 hex
wrench. Use only genuine replacement parts as
recommended by Sears.
4. v'CHECK THE FUEL TANK.
Fill with a clean, fresh fuel mixture according to
the instructions in the "Fuel Mixture" section.
NOTES
-6-