Operator's Manual CRgFTSMRNo 24cc/1.3 cu.in. 2-Cycle 17 Inch Cutting Path GASOLINE WEEDWACKER _ Model No. 358.796200 Read and follow all Safety Rules and Operating WARNING: Instructions before first use of this product. For to your questionsor about this pm, product: Call answers 7 am-7 pm, Mon.-Sat., 10 am-7 Sun. 1-800-235-5878 /,ou_ listed are central Time) Sears, Roebuck and Co.
Warranty Statement Safety Rules Assembly Operation Maintenance Service & Adjustments 2 2 4 5 9 10 Storage Troubleshooting Chart Emissions Statement Illustrated Parts List Spanish Parts and Ordering FULL ONE YEAR WARRANTY ON CRAFTSMAN WEEDWACKER ® LINE TRIMMER 11 12 12 14 17 Back GAS POWERED For one year from the date of purchase, when this Craftsman Gas Powered Weedwacker® Line Trimmer is maintained, lubricated, and tuned up according to the operating and maintenance instructions in the Operator's Man
rotatingline. Keepchildren,bystanders, andanimals50 feet (15 meters) away.If approachedstop unit immediately. • Make carburetor adjustments with lower end supported to prevent line from contacting any object. • Keep others away when making carburetor adjustments. • Use only recommended Craftsman accessories and replacement parts. FUEL SAFETY EyeProtection • • • • If situationsoccurwhichare not coveredin this manual,usecare and goodjudgement.
• If situationsoccurwhich are not covered in this manual, use care and good judgment. If you need assistance, call 1-800-235-5878. SPECIAL NOTICE: This unit is not equipped with a temperature limiting muffler and spark arresting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washington require by law that many internal combustion engines be equipped with a spark arrestor screen.
KNOW YOUR TRIMMER READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. Assist Handle Tube Trimmer Head Shield Throttle Trigger ON/STOP Switch Line Limiter Blade Starter Rope choke lever Primer Bulb Fuel Mix Fill Cap ON/STOP SWITCH CHOKE The STOP switch is used to stop the engine.
Che°"oe ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. Never use engine er products in the nent damage may See the STORAGE al information. STOPPING Bulb • Pull starter rope handle sharply 6 times.
DIFFICULT STARTING OR STARTING A FLOODED ENGINE To Advance Line: • Operate the engine at full throttle. • Hold the trimmer head parallel to and above the grassy area. • Tap the bottom of the trimmer head lightly on the ground one time. Approximately 2 in. (5 cm) of line will be advanced with each tap. To advance line, tap bottom of trimmer head on ground one time. Flooded engines can be started by placing the choke lever in the OFF CHOKE position; then, pull the rope to clear the engine of excess fuel.
monuments, etc. This technique creases line wear. Scalping • The line will easily remove grass and weeds from around walls, fences, trees and flower beds, but it also can cut the tender bark of trees or shrubs and scar fences. To help avoid damage especially to delicate vegetation or trees with tender bark, shorten line to 4-5 in. (10-13 cm) and use at less than full throttle. MOWING - Your trimmer is ideal for mowing in places conventional lawn mowers cannot reach.
MAINTENANCE SCHEDULE CARE & MAINTENANCE TASK WHEN Check for Loose fasteners and parts Before each use Before each use Check for damaged or worn parts Clean unit and labels After each use Clean air filter Every 5 hours of operation Replace spark plug GENERAL RECOMMENDATIONS Yearly flammable solvent to avoid creating a fire hazard or producing harmful evaporative emissions. The warranty on this unit does not cover items that have been subjected to operator abuse or negligence.
REPLACING THE LINE • Push and hold the ON/STOP switch in the STOP position until the unit has fully stopped. • Disconnect the spark plug wire. • Remove the spool by firmly pulling on the tap button. • Clean entire surface of hub and spool. • Replace with a pre-wound spool, or cut two 12.5 foot (3.8 m) lengths of .080" (2 mm) diameter Craftsman brand line. Never use wire, rope, string, etc., which can break off and become a dangerous missile.
tion. If enginedoesnot start, refer to troubleshootingchart or call 1-800-235-5878. • If engineperformanceis acceptable at the presetpositions,no further adjustmentis necessary. grass. Based on performance while cutting, turn the mixture adjustment in 1/16-turn increments as follows: ADJUSTING Do not adjust by sound or speed, but judge by how well the engine performs while cutting. • Counterclockwise if the engine has speed but dies or lacks power while cutting.
TROUBLESHOOTING CHART TROUBLE CAUSE REMEDY Engine will not start. • Engine flooded. • See "Starting Instructions." • Fill tank with correct fuel mixture. Install new spark plug. Check for dirty fuel filter, replace. _ Fuel tank empty. Spark plug not firing. • Fuel not reaching carburetor. • Compression Engine will not idle properly. Check for kinked or split fuel line; repair or replace. • Contact your Service Dealer. low. • Idle speed set too low. • Idle speed set too high.
is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by SEARS. OWNER'S WARRANTY RESPONSIBILITIES: As the lawn and garden equipment engine owner, you are responsible for the performance of the required maintenance tisted in your Owner's Manual.