Manual
Table Of Contents
- Assembly
- Installation
- Determine the Header Bracket Location
- Install the Header Bracket
- Attach the Rail to the Header Bracket
- Position the Opener
- Hang the Opener
- Install the Lights
- Attach the Emergency Release Rope and Handle
- Fasten the Door Bracket
- Fasten the Door Bracket (Continued)
- Connect Door Arm to Trolley
- Connect Door Arm to Trolley (Continued)
- Attach the Warning Labels
- Install the Door Control
- Install The Protector System®
- Electrical Requirements
- Aligning the Safety Reversing Sensors
- Adjustment
- Operation
- Troubleshooting
- Repair Parts
- Accessories
- Warranty
- Notes
INSTALLATION STEP 3
Attach the Rail to the Header Bracket
1. Position the opener on the garage floor below the header
bracket. Use packing material as a protective base.
NOTE: If the door spring is in the way, you will need help.
Have someone hold the opener securely on a temporary
support to allow the rail to clear the spring.
2. Position the rail bracket against the header bracket.
3. Align the bracket holes and join with a clevis pin as shown.
4. Insert a ring fastener to secure.
Temporary Support
Garage Door
Header Bracket
Idler Pulley
Header Wall
Header
Bracket
Mounting
Hole
HARDWARE SHOWN ACTUAL SIZE
Clevis Pin 5/16"x1-1/2" Ring Fastener
14