f Save This Manual For Future Reference owner's manual MODEL NO. 113.177890 I:RRFTSMRN Serial Number Model and serial numbers may be found on the handle. You should record both model and serial numbers in a safe place for future use. FOR YOUR SAFETY 16 GALLON FULL BLOWING WET/DRY VAC • assembly • operating • repair parts READ ALL INSTRUCTIONS CAREFULLY Sears, Roebuck and Co., Hoffrnan Part No_ SP6229 Estates, IL. 60179 U.S.A. Printed in U.S.A.
• FULL ONE YEAR WARRANTY ON CRAFTSMAN WET/DRY VACS '_ If within one year from the date of purchase, this Craftsman Wet/Dry Vac fails due to a defect in material or workmanship, Sears will repair it, free of charge. If this Craftsman Wet/Dry Vac is used for commercial or rental purposes, this warranty coverage applies for only 90 days from data of purchase. WARRANTY SERVICE IS AVAILABLE NEAREST SEARS SERVICE THE UNITED STATES.
Toavoidinjuryfrom accidental starting, unplug power cord before changing or cleaning filter. To avoid fells, use extra care when cleaning on stairs. This Wet/Dry Vac is double-insulated, eliminating the need for a separate Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. grounding system. Use only identical replacement pads. Read the instructions Do not use with damaged cord, plug or other pads.
Introduction This Wet/Dry Vac is intended for household use only. Owner's Page Warranty Information ............................. Safety Instructions ................................. Introduction ............................................ Unpacking and Checking Carton Contents ............................. - In dry areas or when the relative humidity of the air is low. To reduce the frequency of static shocks in your home the best remedy is to add moisture to the air with a console humidifier.
Float/Cage Assembly WARNING: For your own safety, never connect plug to power source outlet until all assembly steps are complete and you have read and understood the safety and operation instructions. Do not operate vac with any parts damaged or missing. 1. Place the power assembly of vac NOTE: If filter cage needs to be removed, because the float is placed in the wrong way, use a fiat blade screwdriver and insert the blade near one of the tabs between the filter cage and the center ring of the lid.
Caster/Caster Foot Assembly 1, Remove the power assembly from the dust drum and set aside. 7. Turn the drum upright. 2. Turn the dust drum upside down on the floor. 3. Insert the caster feet into the bottom of Caster -_ drum, as shown (4 places). 4. Push on the caster foot until the foot is flush with bottom of the dust drum. Caster--Foot 5. Insert the caster stem into the socket of Pin the caster foot, as shown (4 places). 6.
6. Insertthe softend ofthe hose,whichis oppositethe swivelend,into the vacuum port directlyabovethe drain. 7.Placethe utilitynozzlesecurelyon the swivelendof the hoseandthe vac is readyfor use. NOTE: The swivel end of the hose is removable if more hoses need to be attached for more length from the vac. To remove the swivel portion of the hose, grasp the hose swivel and firmly pull it out of the flexible hose.
Operation WARNING To reduce the risk of fire or explosion, do not operate this vac in areas with flammable gases, vapors or explosive dust in the air. Flammable gases or vapors include but are not limited to; lighter fluid, solvent type cleaners, oilbase paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to; coal, magnesium, grain or gun powder. Do not vacuum explosive dust, flammable or combustible liquids or hot ashes. Do not usa this vac as a sprayer.
Emptying the Drum accidental starting, unplug power I cord ARNING: avoid injury from before To emptying the drum. 1. The vac comes equipped with a drain for easy emptying of liquids. Simply unscrew the drain cap and lift the opposite side slightly to empty the drum. 2. Another option is to remove the power assembly. Pull the flexible latches outward on each side of the lid to release from the drum. Moving the Vac 1.
Maintenance Filter IMPORTANT: blower wheel and motor, always reinstall the filter before using the vac for dry material pickup. dental starting, unplug power cord WARNING: To avoid injury from accibefore changing or cleaning filter. Dry Filter NOTE: This filler is made of high quality paper designed to stop very small particles of dust. The filter can be used for wet 1. Some removal of dry debris can be accomplished without removing the filter from the vac.
Wet Nozzle 2. Using both hands, lower the nozzle body onto the insert and squeegee with the round opening of the nozzle closest To pick up liquids off a smooth surface, use the 2-112" wet nozzle accessory supplied with your wet/dry vac. To use this nozzle, simply attach the nozzle to the end of an extension wand. Connect a second extension wand to the to you.
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.177890 Always order by Part Number - Not by Key Number WARNING SERVICING OF DOUBLE-INSULATED In a double-insulated Instead of grounding. WETIDRY VAC Wet/Dry Vac, two systems of insulation are provided No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added.
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.
£RRFTSMRN Accessories and Attachments Get more versatility from your Craftsman wet/dry vacuum by adding these accessories. Additional wet/dry vac accessories may be purchased at your local Sears retail store or Sears/Craftsman Power and Hand Tool Catalog.
6934 HoseGrip 16917HoseJoiner 16930HoseLock 16935Gutter Nozzle Sawdust Collection Series Whole-shop Sawdust Manifold-Type Collection System 29964 Radial Arm Saw Dust Collection Kit 29963 Table Saw Dust Collection Kit 29962 15
For in-home major brand repair service: Call 24 hours a day, 7 days a week 1-800-4-MY-HOME (1-800-469-4863) Para pedir servicio de reparacibn a domiciUo- 1-800-676-58tl For the repair or replacement parts you need: Call 6 am - 11 pm CST, 7 days a week PartsDirect 1-800-366-PART (1-800-366-7278) Para ordenar piezas con entrega a domicilio - 1-800-659-7084 For the location of a Sears Parts and Repair Center in your area: Call 24 hours a day, 7 days a week 1-800-488-1222 For information on purchasing a