Save This Manual for Future Reference SEARS owner's manual MODEL NO. 113.170330 CRRFTSMRN® Serial Number Model and serial numbers may be found on the side of the detachable blower. You should record model and serial numbers place both in a safe for future use. 16 GALLON WET/DRY VAC WITH DETACHABLE BLOWER • assembly • operating • repair parts FOR YOU R SAFETY READ ALL INSTRUCTIONS CAREFULLY k= J Sears, Part No. SP6481 Roebuck ,J and Co., Hoffman Estates, IL. 60179 U.S.A.
FULL ONE YEAR WARRANTY ON CRAFTSMAN WET/DRY VACS If within one year from due to a defect If this Craftsman this warranty Warranty the date of purchase, in material or workmanship, Wet/Dry coverage Service Vac is used applies Is Available vice Center/department This warranty This warranty rights gives for commercial By Simply only while you specific Wet/Dry Vac fails or rental purposes, for only 90 days from Throughout applies this Craftsman Sears will repair it, free of charge.
Toreduce theriskofinjuryfromacciden- Vacsbefore servicing. talstarting, unplug powercordbefore UsethisWet/dry Detachable Blower Vac asdescribed inthismanual. changing orcleaning filter. Whenusingasdetached blower: Donotunplug bypulling oncord.To unplug, grasptheplug,notthecord. •Turnunitoffbefore setting onground or Donotusewithdamaged cord,plugor releasing grasp fromhandle. otherparts.IfyourWet/Dry Vacisnot •Donotuseonwetsurfaces, electric working asitshould, hasmissing parts, shockcouldoccur.
Introduction This Wet/Dry Vac is intended hold use only. IMPORTANT Please Table of Contents for house- Item Page Warranty Information ............................. 2 Safety instructions ................................. 2 Introduction ............................................ 4 NOTE Read Carefully Static Shocks Are Common - In dry areas or when the relative humidity of the air is low.
Accessory 1. Unlatch Caddy Assembly the drum latches on the front and rear of unit. The drum the lid onto the drum. latches drum. Place the lid upside clean smooth surface. 2. Flip the drum upside down down 3. Take the accessory on a Orain Cap and position The open horseshoe shaped caddy positioned under the open Dove Tail on the floor. caddy it on the vac drum. 4. Slide the caddy Accessory Caddy hold Lift the lid off the end of should be the drain cap.
Float/Cage Assembly WARNING: For your own safety, never connect plug to power source outlet until all assembly complete understood the safety instructions. 1. Remove vac with or missing. the detachable head assembly down on the power blower from the by pressing head latch beneath the carry handle of the detachable blower. Set the detachable blower the side. drum. 2.
Filter Assembly 1. Carefully cage, _ slide the filter over the filter sliding it over the center ring cov- __-'- ering the 3 slots until the filter stops against 2. Place Filter Nut Filter Plate the lid. the hole in the filter plate over threaded 3. Gently screw Filter of the filter cage. push on the filter plate to seat the rubber cular channel tighten NOTE: of the filter plate. it down. Finger screw and tighten only. Lever of filter nut should be away plate as shown.
Positioning Detachable Blower (Power Head Assembly) 1. Locate the detachable Craftsman wet/dry blower 2. On top of the blower (opposite dle side of the blower); plastic Molded Plastic Lead of your vac. there the hanis molded lead that is used to assist assembling the unit. Position into the indented area above the lead the label. ndented Area 3. Rotate the detachable blower down until the travel of the unit stops. 4.
Operation V V/'_ r_ I_l I I_l v_._ To reduce the risk flammable gases paints, gun gasoline, powder of fire or explosion, or flammable alcohol vapors or explosive in the air. Do not vacuum ble liquids or hot ashes. hazards reduce Unplug drum.
Operation (continued) 4. When the liquid in the drum reaches a predetermined level, the float mechanism will rise automatically to cut off airflow. When this happens, turn off the vac, unplug the power cord, and empty the drum. You will know that the float has risen because vac airflow ceases and the motor noise will become in pitch, due to increased motor IMPORTANT: To reduce age to the vac higher speed. the risk of dam- do not run motor with float in raised position.
To Store Your Accessories Your Craftsman accessory pockets caddy wet/dry storage. located and two vac There at the storage caddy is are five storage rear areas of the vac at the front of the storage caddy. Conveniently store designed to provide better stability and accessory nozzles and extension wands I_ on the rear of the caddy and use the front storage for hose storage and/or male to male and air diffuser storage.
Operation (continued) Moving Should the Vac it become necessary to pick the die vac up to move it, the handles may be used on the sides of the dust drum. Do not use the handle able blower located on the detach- to pick up the entire wet/dry vac or the lid assembly. Handle Blowing Your Feature wet/dry blower". vac features a "detachable It has the capability a dedicated blower WARNING: Always gles complying using WARNING: blowing inhaled.
The wet/dry blowing vac using may the plied with the wet/dry install the blower also seven be foot used hose for inside of the push button end of the vac hose. Assemble the hose to the blower sup- vac. adapter adapter port of the wet/dry vac. The blower adapter will in the blowing insert into and connect the opposite the blower nozzle to end of the hose. The unit is ready for blowing applications.
Maintenance Cleaning Dry Vac Filter Your filter should maintain (continued) be cleaned often to picking storing top of the lid while filter with holes or tears in it. Even open a small of high quality when removing the filter to clean carefully or installing through the filter for cleaning remove the IMPORTANT: To reduce vac for dry material filter is removed, under "Wet Filter".
Wet Nozzle farthest To pick up liquids use the 2-1/2" off a smooth wet nozzle plied with your wet!dry surface, accessory a second extension may be picked nozzle across will dry the surface Replacement nozzle Parts. to the be flipped thumbs _, , - lower opening holding removable the latches the - = - * = • .
Repair Parts 16 Gallon Wet/Dry Vac With Detachable Model Number 113.170330 Always order by Part Number Blower - Not by Key Number WARNING SERVICING In a double-insulated instead of grounding. appliance, should a means Vac requires be done for grounding extreme only by qualified double-insulated double-insulated Wet/Dry Wet/Dry and the symbol ance. r_-I(square Key No. WET/DRY Part No. care be added. personnel.
Repair Parts 32 34 17
£RAFTSMAN® Accessories and Attachments Get more versatility from your Craftsman wet/dry vacuum by adding these accessories. Additional wet/dry vac accessories may be purchased at your local Sears retail store or Sears/Craftsman Power and Hand Tool Catalog.
16934 Hose Grip 16917 Hose Connector 16930 Hose Lock 16935 Gutter Nozzle Sawdust Collection Series Whole-shop Sawdust Manifold-Type Collection System 29964 Radial Arm Saw Dust Collection Kit 29963 Table Saw Dust Collection Kit 29962 19
For in-home major brand repair service: Call 24 hours a day, 7 days a week 1-800-4-MY-HOME Para pedir servicio (1-800-469-4663) de reparacion a domicilio- For the repair or replacement 1-800-676-5811 parts you need: Call 6 am - 11 pm CST, 7 days a week PartsDirect 1-800-366-PART Para ordenar (1-800-366-7278) piezas con entrega For the location a domicilio - 1-800-659-7084 of a Sears Parts and Repair Center in your area: Call 24 hours a day, 7 days a week 1-800-488-1222 For information o
