Save This Manual For Future Reference SEARS owner's manual MODEL NO. 113.177920 £RRFTSMRN® i Serial Number Model and serial numbers may be found on the handle. You i should record both model and serial ' numbers in a safe place for future use. FOR YOUR SAFETY 16 GALLON FULL BLOWING WET/DRY VAC • assembly • operating • repair parts READ ALL INSTRUCTIONS CAREFULLY Sears, Part No. SP6436 Roebuck and Co., Hoffman Estates, IL. 60179 U.S.A. Printed in U.S.A.
FULL ONE YEAR WARRANTY ON CRAFTSMAN WET/DRY VACS If within one year from the date of purchase, this Craftsman Wet/Dry Vac fails due to a defect in material or workmanship, Sears will repair it, free of charge.
To reduce the risk of injury from acciden- To reducethe risk of falls, use extra care tal starting, unplug power cord before when cleaning on stairs. changing or cleaning filter. This Wet/DryVac is double-insulated, Do not unplug by pulling on cord. To eliminatingthe need for a separate unplug,grasp the plug, not the cord. groundingsystem. Use only identical replacementparts. Read the instructions Do not use with damagedcord, plug or for Servicing Double-InsulatedWet/Dry other parts.
Introduction This Wet/Dry Vac is intended Owner's for house- hold use only. Shocks Are Common areas or when the relative air is low. To reduce static shocks Contents Item IMPORTANT NOTE Please Read Caref'ully Static Manual - In dry humidity the frequency of the of in your home the best rem- edy is to add moisture console humidifier. to the air with a Page Warranty Information ............................. Safety Instructions ................................. Introduction ................
Float/Cage WARNING: For your never connect outlet Assembly plug to power until all assembly complete instructions. read and Do not operate 1. Place the power down away from the lid. To replace, cage assembly of vac injury hands, other foreign objects ter opening float. Power Assembly the risk of or damage sure to keep instructions. Tabs opening in the center of the lid with the words "This Side Towards Lid" laying face down over the hole.
Caster/Caster Foot Assembly 1. Remove the power assembly dust drum and set aside. 2. Turn the dust drum floor. 3. Insert the caster upside drum, as shown Caster U_. Caster Stem -_ Caster Ball foot until the foot is of the dust drum. 5. Insert the caster upright. __,.i of (4 places). flush with bottom 7. Turn the drum down on the feet into the bottom 4. Push on the caster the caster from the stem into the socket of foot, as shown Caster--=Foot Pin (4 places). 6.
6. Insert the push button end of the "Pos-ILock" hose into the inlet of the vac. The hose should snap into place. To remove button in the hose assembly and pull the hose out of the vac inlet, as shown. the utility opposite ready nozzle securely forcing end of the hose and the vac is together a 9-16917 connec- connector end of the hose connected the other hose by until they fit - OR hose-hose tor. Install the hose-hose connect on the end of the original the sections tightly.
Operation WARNING To reduce the risk of fire or explosion, flammable gases, vapors or explosive do not operate this vac in areas dust in the air. Flammable with gases or vapors include but are not limited to; lighter fluid, solvent type cleaners, oilbase paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to; coal, magnesium, grain or gun powder. Do not vacuum explosive dust, flammable or combustible liquids this vac as a sprayer.
Emptying Moving the Vac the Drum WARNING: To reduce injury accidental from unplug power the drum. 1. Should the risk of necessary up by the lid handles emptying is empty. To reduce unless equipped for easy emptying unscrew with a drain of liquids• Simply the drain cap and lift the oppo- site side slightly 2. Another option to empty the drum. is to remove the power assembly• Pull the flexible latches outward on each side of the lid to release from the drum. 3.
Maintenance Filter IMPORTANT: WARNING: To reduce unplug power or cleaning age to the blower the risk of injury from accidental changing Dry filter. This filter is made of high quality performance Cleaning maintain be cleaned often to storing hole can cause results your vac. Replace Cleaning SHOULD doors and not in the living by gently replacement, unsc_ew WARNING: remove fingers wheel.
2. Using Wet Nozzle to you. With fingers on the far side and thumbs holding the latches of the vac. To use this nozzle, simply attach the nozzle to the end of an extension wand. Connect a second extension wand to the first, and connect the 2-1/2" the extension wand.
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.177920 Always order by Part Number- Not by Key Number WARNING SERVICING OF DOUBLE-INSULATED In a double-insulated Wet/Dry instead of grounding. appliance, nor should insulated should Wet/Dry be done Vac, two systems extreme only by qualified care and knowledge service double-insulated Wet/Dry Vac must double-insulated Wet/Dry Vac is marked and the symbol ance. [--_(square within personnel.
Repair Parts 16 Gallon Wet/Dry Vac Model Number 113.
£RRFTSMRN® Accessories Get more versatility ries. Additional wet/dry or Sears/Craftsman 17820 2-1/2"x7' 16922 Utility 16978 and Attachments from your Craftsman vac accessories Power wet/dry vacuum may be purchased by adding these accesso- at your local Sears retail store and Hand Tool Catalog.
16934 Hose Grip 16917 Hose Joiner 16930 Hose Lock 16935Gutter Nozzle Sawdust Collection Series Whole-shop Sawdust Manifold-Type Collection System 29964 Table Saw Dust Collection Kit 29962 Radial Arm Saw Dust Collection Kit 29963 15
For in-home major brand repair service: Call 24 hours a day, 7 days a week 1-800-4-MY-HOME (1-800-469-4663) Para pedir servicio de reparacibn a domicilio - 1-800-676-5811 For the repair or replacement parts you need: Call 6 am - 11 pm CST, 7 days a week PartsDirect 1-800-366-PART Para ordenar piezas (1-800-366-7278) con entrega a domicilio - 1-800-659-7084 For the location of a Sears Parts and Repair Center in your area: Call 24 hours a day, 7 days a week 1-800-488-1222 For information on