Model：EP22916 WARM TIPS :This product is recommended for use in 108-162 square feet of the room.
TABLE OF CONTENTS________________ SAFETY INSTRUCTIONS.................................................................. SAFETY SYMBOLS............................................................................. UNPACKING........................................................................................ PARTS DESCRIPTION........................................................................ ASSEMBLY.................................................................................
Never locate the heater where it may fall into a bath tub or other body of water. 14. Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or the like. Arrange the cord away from traffic areas and where it will not be tripped over. 15. Do not use on soft surfaces, like a bed, where openings may became blocked. Do not place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. 16.
SAFETY SYMBOLS__________________________ UNPACKING__ __________ _______________ Check immediately whether all parts and accessories are present in the box. If anything is missing or broken, contact our Customer Service at 1-866-206-0888. PACKAGING INCLUDES: --Caster brackets (X2) --U-bolt (with right angle bend) (X2) --Butterfly bolts (X4) PARTS DESCRIPTION 1. ...... ......... ....................... Oil fins (x7) 2. Carry handle 3. LCD Digital Display 4. Timer Setting & Power Setting Button 5.
ASSEMBLY....................................................... — The heater is packaged with the feet unattached. You must attach them before operating the heater. CAUTION: Do not operate this heater without casters attached. WARNING: Do not operate without feet attached. Do operate the heater only in upright position (feet on the bottom, controls on the top), any other position could create a hazardous situation. Assembly Instructions: Unpack the heater and remove all parts from the packaging.
OPERATING INSTRUCTIONS__________ _........ Control Panel: Figure A Figure B WARNING: Do not operate the product until fully assembled; do not operate without the casters attached. 1. Before using the heater make sure that it is on a flat and stable surface. Damage may occur if it is placed on an incline or decline. WARNING: Operate the product in an upright position only.
2. Set all the power switch to OFF position, and plug the Power Cord into a standard 120-volt AC electrical outlet. 3. Press the Power Switch Button (”5” in Parts description) first, and then press the Power Button once, and the LCD will turn on. 4. To set the required function, proceed as follows: Power setting: Press the “ ” button in succession until the power setting icon on the LCD flashes. Use ▲ and ▼ button to set your desired power setting.
CLEANING AND STORAGE________...... .. Before any cleaning, make sure that the heater is turned off and plugged from the power source. Regular Cleaning: 1. Prepare a mild detergent-water solution. Do not use cleaning liquid or other chemicals to spray directly on the unit. 2. Use a clean, soft and lightly damp cloth to gently wipe off the dirt from the surface of the unit only. 3. Do not attempt to open the heater to clean it. Doing so will damage the unit and void the warranty.
TROUBLESHOOTING.................................................. If your heater fails to operate, please follow these procedures before contacting Customer service: Problem Probable Cause Solution Unplug and turn the heater off; allow it to The thermal cut-off has been activated cool for 30 minutes. Once the heater has cooled off, check to make sure that there are no objects on or adjacent to the unit. To resume operation, plug the unit back in.
PARTS LIST Please refer to the schematic drawing on the next page. No. 1 2 3 4 5 6 7 8 9 10 11 DESCRIPTION S-TYPE BODY SCREW ELECTRIC BOARD SCREW FRONT COVER LCD COVER CONTROL PANEL SCREW SCREW COVER KEY-PRESS BUSHING Qty 1 4 1 3 2 1 1 1 1 1 1 No. 16 17 18 19 20 21 22 23 24 25 26 12 13 14 15 POWER CORD NTC COVER NTC BASE CORD STORAGE 1 1 1 1 27 28 29 30 DESCRIPTION SCREW SCREW CORD CLAMP HOLDER CORD CLAMP SCREW THERMAL LINK HEATING TUBE PRESSURIZED WASHER WING NUT WHEEL ASSY.
